Viewing all customer Discussions for:

Other

I need a window balance. I expect that it is the same as you have sent me in the past. CUSTOM - S752-26-A91-Q0352 Name: 26C Series 752 Type B Balance This is for a pennco tilt in window. Please provide correct replacement balance information. Thanks. DaveD

Attached are pictures of a broken part that I need to replace. The last picture is an operable one installed

HelloI have an Anderson Frenchwood Hinged Patio Door and the lock does not work. I believe the part in the attached photo should have a spring that slips over it that would hold in a locked position. I purchased the spring at our local hardware store but it is just a little too tight. Would I be ... (cont.)

Hi, I have a large number of pivot shoe locks that all have broken cams. I was wondering if I can purchase the cams individually, without replacing the entire pivot shoe. The pivot shoe is the 15-178 model.

We need a replacement patio door handle.

Hi, any help identifying replacements for these (circa 1980's?) would be appreciated! Upper hardware appears to be a rectangular nylon slider, lower is rollers. Each locks in to a basic metal frame.

We have an old casement window. I don't know the manufacturer (hence my reason for contacting you). Do any of you recognize it? There's only one identifying mark stamped on the short portion of the split arm. The long portion of the arm is about 5 inches. Sorry I forgot to measure the mounting hole ... (cont.)

Good day! I am looking for a small plastic part that holds the window shut on a casement (crank-type) window. It measures 1 3/4" long x 3/4" wide. Screws are 1" on center. There are 3 on this particular window and helps draw the window closed. Any help you can provide would be most beneficial. Thank ... (cont.)

I am searching (unsuccessfully) for four of these drawer pulls for a Henredon "Four Seasons" dresser. Hope you can help. You can see from the picture that the left side of the pulls has broken off. The distance between drawer holes is 5 3/4".

I'm looking for the edge piece that separates the two panes of glass on a dual glazed window panel. The piece that is shaped like a 1/2" X1/2" rod around the perimeter between the two panels of glass.

I need 2 if available thank you

Handles

In need of Sash balance with plastic white sleeve, blue nylon tip

I believe this may be a Truth window crank. I have ordered and it is not your part number 39-107FK. The folding handle is 5 inches long (almost the entire length of the housing. As you can see the shaft is closer to the end of the housing as opposed to the middle on the 39-107FK. Any help would be a ... (cont.)

I need some advice on part number to order. need a new coil balance. thanks

A friend of mine asked me to look at the window after her son moved out to attend college. Upon investigation it appears (my thoughts) the window was removed for cleaning an then placed back in improperly and forced closed resulting in damaged to bottom of window frame and Pivot Bar completely missi ... (cont.)

Please let me know what part number is needed to order. Stamped with: B.S.I pp 26 4 Measurements sent in photos and below. Length just metal 26 7/8" Wide 1/2" Depth 5/8"

#2 TO FIT 23" TENSION FA2240

Hello, I have been able to get replacement parts from you to repair most of my broken cranks. It has been great! Unfortunately I am missing a crank and I have already purchased two replacements that did not work. I will send them back eventually. This time I decided to leave it up to the expert ... (cont.)

I would like to get the correct coil balance part #. It looks like both sides need replacing.