Viewing all customer Discussions for:

Other

Do yall have this handle for my impact sliding door?

I cannot find this part

I have to replace window tilt latches on a number of my vinyl windows. I've attached a picture of the current latch and the window sill without the latch installed. The dimensions match the dimensions on your part number 26-244A. Do you think these will fit properly?I bought similar latches from ... (cont.)

Can these be replaced just from a model number? It's a model 5900 single hung window.

Hello, I'm looking for wool pile recommendations for Milgard V250 windows. The existing wool pile on my windows is very worn out, but rough measurements showed ~1/4" base and ~1/8" height. I'm curious if Milgard V250 windnows just use a standard size that I can purchase

Need 6 sliding patio door roller assemblies as per attached photos

I need several, all are the same. Length of channel, metal only is 27". Width is 1/2" on non open side. Open channel side has a small lip and is 5/8 across opening. Opening part of window is 20 pounds. I've included pictures of top and bottom as I need help identifying which one. Off hand I thought ... (cont.)

can't find one with the wings on the outside edge

Let me know if you have those and how much per each one. Thank you

hi -- this looks to be a tilt dash for an aluminum double hung window. Seems to measure 2-3/8 center to center but maybe it's really 2-5/16.

The hand came off with the shaft in it. Please let me know which part is needed.

Replacements lock/handle previously purchased from your firm..need again

I am hoping you carry this brand. There is a plastic housing at the jamb side moveable up and down but the strike plate or receiver plate is missing.

I need two of 1/2" wide non- tilt window channel banlances, 24.9" long

Door1 (2 photos attached): This is a handle with a built in latch mechanism. The mounting screw holes are 2.5" on center. The handle is missing so I cannot provide a photo of that. Door2 (3 photos attached): The handle on this door is fine, however, the separate latching mechanism knob is snapped of ... (cont.)

Hi, I’m trying to replace Better Bilt window balancers, I’ve identified the 28" long and 3/8" thick, Series 900 red tip Spiral Tilt Window balancer as a possible replacement. Do these photo’s confirm this model?

I am trying to find the plate the latches hook into. Would you kindly guide me in my search.

locks window and tilts to remove window, slides in track

2265 listed at the top of the handle. Sash Controls Ferndale, MI

I'm trying to find a replacement handle and strike plate for my slider