Viewing all customer Discussions for:

Other

From what my customer is saying it's a bypass door. Don't know if they know exactly. Let me know what you think. ThanksDaniel

We have a Superior Lock Set. The handle on the door we open has lost its spring action. Do you have the part to fix it?Lee

Hello, I am looking to replace the latch track on several atorm windows (pictures attached). Do you carry this part? Thanks, Adam

Eagle Maximizer Plus 03/2006. NFRC 099-014/022/045/046/047/063/064 I need the nailing fins for (3) of these windows. 3'x5'

The top plastic piece is broke on one side and the other side doesn't look long for this world either. Thanks so much, Steve

Spring assembly for non tilt aluminum window from 1965 building

I recently purchased 26-420 and 26-419 tilt latches for my windows. Everything size wise fits except for the clip that holds it in the window. It is shown as 3/8" in the attached picture. Do you have this same latch but with the clip at 1/8" or 3/16"? Thank you!

I am looking for a pivot bar for my window. The number on the bar is R-1588-2.

4 of the pix shows the coil spring, I think it's broken. Can I get just the coil spring only, and which one. The other pix shows the bottom of the spiral spring, the cylinder is 3/8" x27" long, that sash is about 5 lbs.

My dad custom built these mirrored bifold closet doors in the early-mid 80s. I thought I repaired them but if I'm being honest, it was probably a temporary fix. It seems like the tracks (bottom/top) themselves are probably fine. However, I could see a new bumper-- at least on the bottom track and d ... (cont.)

bar is 7/16 wide at the widest end, 5/16 the rest of body, 3/16 thick.

Hi Team, We have a broken tension boot part that I was hoping you could identify and advise regarding a replacement. The window is a double-hung vinyl replacement window that is about 15 years old. I do not know the manufacturer. I attached 2 pictures...1 of the broken metal "U" shaped boot piece a ... (cont.)

I need to install drip edge on the outside bottom of all doors made by Loewen doors. Do you carry Drip Edge? Thanks, Jaiswal

I have a customer needing this part. He believes it to be Milgard # 538085. I need to know if you carry this item (if that is correct), and the cost. thank you,

I need to replace the balances for 2 wimdows. The length is 21 inches. I weighed the window sash It's 21.5 lbs.Could you let me know the correct part number and can I order it from you?

I have a BSI window balance stamped: 1420 BSI VC. Do you carry this particular item?

Can you help me identify this lock type? The screw holes measure 3 3/4" center to center. The whole unit measures 4 1/2" in total length (could be 4 9/16).

can you help me validate this is the right one based on the pictures .270 T-Slot Foam Filled Bulb Weatherseal,12ft

Need a lot of replacement weatherseals for jeld-wen windows that were installed (I think) around 2006. Thank you

I have been trying to find a tilt latch similar to this, but the ones I have found are slightly off and I have to use a Dremel tool to shave off the excess plastic that would prevent it from fitting, But they are still a tight fit. I have several windows like this in my house and my neighbors have a ... (cont.)