Viewing all customer Discussions for:

Other

window clips

Do you have a part like this. Resembles your 90-077A, but distance from frame to center of screw hole is 15/16th instead of 7/16th. Manufacture of window is Atrium. And they are about 18 years old.

I have a broken round drawer socket from cabinets 40 years old. The metal drawer rod is 7/16 wide and 15/16 high. It appears to me that this would work as a replacement. What do you think?

Good Morning: We are searching for two things for our Simonton ProFinish Double Hung windows. 1. We are looking to purchase replacement window latches (plastic) for both sides, left and right that are spring loaded and slide into the top of each side of the windows in order to lock them back in th ... (cont.)

I am looking for replacement sliding glass door handles with "latch" locks. House was built in 1972; I thought they were Andersen but now am not sure (local Andersen dealer did not recognize, but said they might be pre-1970).5 1/4" between screws; piece that goes on door directly is 71/4" in lenth, ... (cont.)

Hi - I have an awning window that has a broken keeper lever, but I can't identify the window maker or hardware brand.

25.5" channel

Hello, Would you help me to identify this operator for Andersen Casement please? If Swisco sale this hardware can you tell me whats the product number. Thank you.

broken coil balancer from land double hung window

Hello, Trying to determine if you have a crank replacement for my window.

I am in need of the handles (only ) for a ply gem 1500 series sliding patio door. The lock is in good shape just looking to reap a the handles (white). Can you help ?

These windows are near the ocean in Hawaii. The hardware is rusted and in one location it's turn the plate under the crank into a powder. Any replacement hardware would need to be stainless. When looking at the photos, the photo of the casement hardware shows the weathering of the plate I menti ... (cont.)

This is the only photo we have and we do not have measurements. I know, I know, these guys didn't get measurements! We're looking to replace this weather stripping. They said that theere is a "trim" cover that should have gone on top of this but I can not confirm that. I'll try to see if I can get t ... (cont.)

I am looking for hinge limiters for my DTC hinges with cabinet doors near my walls. I can't identify what model of hinge this is or find the correct hinge limiter for my hinges. Could you please help me?

Length - 19 1/8" Stamp - 19 5 B.S.I. PL (also visible on picture) Manufacture - Unknown Channel Width - 1/2" (9/16" actual) Channel Height - 10/16" Bottom Guide Height - 1 3/32", Hook as shown on picture is broken Window Weight - Approximately 20 pounds Count Needed - 2 (left and right) ... (cont.)

Original windows. Home built in 1987. Can't find replacements. Your help will be greatly appreciated. Luisa

Bead measures 7/8" with 5/16" hem Thank you

Vynil/plastic spine that the door slides on has broken away from the base track and door can no longer slide. There are no manufacturers markings anywhere to be found. The thermal pane door glass has the IGMAC stamp on it. So, perhaps the door was made in Canada. Is there a replacement for the trac ... (cont.)

Hi, I have what I believe is an MW casement window based on the number on what I think is called the stud bracket. As shown in the picture the studbracket came off the bottom of the window and so the crank no longer works to shut the window. The hinge, crank and operator work fine but I can't figure ... (cont.)

This crank assembly is from a Hurd Window. Hurd is no longer in business. This window was installed in 2000.