Viewing all customer Discussions for:

Other

I have a 1980's window screen for a triple track window Contender Deluxe Tilt. I am looking for the piece seen in photo # 3. As you can see in photos #'s 1 and 2 the "right angle piece" that goes into the track broke off. The underside of the broken piece has the #'s 1025 on it.

Need the correct replacement part.

Need a multi point lockset that has provisions for shoot bolts

Stump: 86 23-3 GB5 CMC 45 Length: 24"

Pella window - 903 TD (1993) Would like to buy screen clip as shown in attached photo.

Hi - I am replacing covers and handles on several windows at home. Two windows have the cover shown, and an 11/32"crank. Should this cover just pop off or is there a set screw? And which is the right replacement cover in white? Thanks! Judy

Thank you

I need 4 of these hinges. The IPad photo has a brass color. The scanned immage attached is somewhat off color.

The only marking on the balancer is 31B and I need the clip on the end of the sash cord. Please see attached photo. Many thanks

Both of my spring balances have disconnected from one of my windows. As I try to reinstall them I believe I need less tension on the spring. I cannot determine if it is possible to lower the tension on the springs and if so, how. If it is not possible, can I order new spring balances from you 27" o ... (cont.)

Milgard stamp 21 3. Aluminum frame

The locking rod brackets that hold the locking rod in place have broken. Is it possible to purchase new one. This is the rod that runs up the side of the window and locks it once you have cranked it shut. There are two of then.

25-2 BSI R6

My sliding glass door handle is broke. Can you please me find a replacement. Thanks

Looking for Channel balance 2920B for 2 windows.

Door wants to catch when I turn knob.

Need 2 replacement window balances, 22 inch long, ½ inch wide metal channel. The sash weighs 14 lbs. The problem I have is that the fittings on the top and bottom don't match any of the fittings you have listed on your site. I was hoping you guys would be able to determine the fittings that best mat ... (cont.)

Need to replace a balance for a Milgard sliding window. Balance 32.5 inches long. Photos attached.Thanks,David

Need to replace a number of these...can you advise part # I need to buy, both "left" and "right" are required. Thanks

It may be a Malta brand. This pin bar is close but not exact.