Viewing all customer Discussions for:

Other

Hopefully this picture helps. Thanks, John

Need a pivot for right side S140-10. Thanks

I'm looking for a keyed sliding glass door handle set for a PGT DH-530-W handle set which I can swap out. Thank you in advance

I have a Marshall Vinyl sliding patio door that recent had the locing mechanism fail. It is a simple push down lock that elevatges a metal clash to secure the door. I an looking to replace this failed lock, if need be the entire handling system could also be replaced. That is the gandle to pull the ... (cont.)

I'm looking for three different types of corners. The standard 90 degree corner (sending another email with additional attachments). And also the corner that is spring loaded and holds the screen in. There is a right and left side of this corner.

Hello , Looking for glazing snap in bead for my home. Windows say Norandex on them and they are single hung aluminum windows in south Florida with snap in plastic bead the house was built in 2005. Not sure if any of this helps Attached is a picture of the actual bead as well as a traced drawing on ... (cont.)

This part I most similar to a "cement Crank, part numbers 39-452 and 39-220B. However, this is not an exact match and would like any information regarding this exact measurements in the photos. Thank you,

Hello, I am looking for a replacement for an old (early 1990s) drawer bracket that gave out. Do you have any suggestions, please? Thank you.

I need a balance spring mechanism for a: Peachtree, double hung, non-tilt window, nominal size 36"x60" total width x height. My existing balance (pictured below) is 26-1/8" longx5/8"x5/8", and has the markings "3660 EL CALDWELL" My window sash weighs approximately 19.5 pounds. I searched your websi ... (cont.)

Looking for replacement spiral balances. The total length is not a whole number. Please advise.

I found you have #90-281 that is very close to my size in my Hurd window. The difference is that mine is not fastened from the top. Instead, it is fastened from the side (like #90-320). I assume that #90-281 will work - or do you know why it would not? I found a discussion under #90-320 referencing ... (cont.)

I am looking for these parts to be replaced. Thank you! Peggy

I'm looking for replacement pat# 5139291 for Anderson windows ; I believe that is the left side. I will also need the right side.

Unsure of part# for replacement lock mechanism. Window is older and not seeing direct replacement. Thank you all for your help. Tomasz

How do you replace a series 500 spiral window balance in a non tilt, non clip window

The internal latch on a replacement window. I've added photos of the inside and the outside. It's 4.5 inches long. Thanks so much!

I'm working on some windows that have some sort of long spring that attaches to the window sash and to a narrow pivot shoe. The top of the breaks over time (it's plastic) it's a pretty common problem with these windows but I cannot identify the parts if they are available or if they can even be repl ... (cont.)

The counter balances seem to come in 1/2 inch and 3/4 inch. the ones I have to replace are 1/2 inch in single hung windows. do you have both styles? thanks

Hi, I couldn't find any markings on these to indicate a weight but the windows are 28 by 44.5. I know they're coil balances but I don't know what size to get. I hesitate to remove them in case I can't get them back in! Thank you for your help! Tara

Hi! I am looking for door threshold replacement part for SGD-R30-120x82 vinyl white door. Do you know which part can replace this?