Viewing all customer Discussions for:

Other

I'm looking for 1 of these. Please help!

Looking for a replacement door handle please. Only identifying mark is "WIPI". Came from a company called Patio enclosures, who don't seem to want to answer the phone. 4" between screws 3/4" throw

Needing sash guides an locks

Hello All, I believe the black plastic piece in the pics has worn out enough that it is popping off of the latch as it is pressed downward to latch the window shut. I've re-attached it three times. It will hold for about 3/4's of the downward motion and then near the end of what would be 'fully la ... (cont.)

I am looking for replacements for these window cranks/mechanism

I purchased a house in south Florida and have awning windows from the 70's. I need the pins/rivots that allow the windows to lock closed when retracted. The attached pictures show the windows and the pin/rivot inserted into the side of the window panel. There is supposed to be one on each side of th ... (cont.)

Do you have the plastic rollers for the top roller of a curved shower door. Your replacement roller number 10-075 looked like it will fit but I only need the plastic roller part.

Hi, I have looked everywhere for this slider assembly on our closet door. I hope you can help.Thank you.Dan

Looking to replace this bent window hing part Can you help?

Couldn't find any numbers anywhere

Hi I would like to purchase new top weather seal for my Milgard windows. The T-Bar hard plastic strip that locks weather seal in place is 3/16 inch. The bulb is 1/4 inch. The fin is 1/4 inch. Thank you for your help. Tim

Hi there, I am lost as to which screen corners would work to replace the old ones here. Thank you!

33.5" long metal to metal Channel inside width .5" Markings on existing spring balance: "33 9" "BSI RM" Window this balance will go into: Milgard Manufacturing code MG-1 Series: 3210 SH Product Line # 032 -15(unreadable after this) I have additional photos if necessary

Please help me find operator for pics sent under help@swisco.com

The picture I'm sending it's of a good (not broken) tilt key for a storm window. The tip of the other one broke off and I've been looking for this type of tilt key to fix the storm window but I can't find anything that looks like it. Could you help me with this search? Thank you! ... (cont.)

I have a 22lb Milgard window & I need to replace both balancers. The balancer has the marking, "32 4 BX CMC 7" The balancer is 33" long

im looking for this seal and can't find it,

This is a casement window that goes out. There are no markings on the window to indicate the manufacturer.

Single pane aluminum windows from log kit home (like Justus Cedar homes) possibly bought from sears. Metal insert installs into vertical channel with a flat roller wheel at bottom, windows slide sideways. Phillips screws into nut to tighten against channel at top of insert. Sending pictures. Hope yo ... (cont.)

Printed as "32 4 EV CMC 7" 33" in length.