Viewing all customer Discussions for:

Other

Hi, We were looking to install your 39-253LB to a casement window. It just looks like the track slider doesn't attach to the casement window. I see that your arm is different from the one the window has already. Your arm where the track is placed is circle and the existing one is rectangular. Pleas ... (cont.)

The dimension of the hexagon "nut" on the winder main body is 5/16ths of an inch across flats. Some have the black plastic from the photo and other only have the nut left.

Hi I came to ask what is that sliver piece on the clamp is it a stud bracket or something else that's holding it together.

This is a Quaker double hung window from Mueller Roofing Distributors. I am in need of several keepers. Please help.

Hi. Attached are photos of an intact and broken window latch installed, and the broken latch, removed. The latches are mounted on the top of a swing-out window frame. No manufacturer or part numbers observed. Hope you can help!

This is the small pin at the bottom of the window that slots into the coil balancer what are they called and do yall sell any

No markings noted. Overall length is 7 inches. Length of straight arm is 4inches. Most likely original when house built in 1950

I'm looking for dresser drawer side mount Length 16 1/4 Width 5/8

There are no part numbers but I have take a picture of the door and 3 pictures of the removed door sweep that I removed from the bottom of the door. The sweep has a single fin that pushes up into the centerline of the bottom of the door. The door is 34' wide and 2" in thickness. Do you have this ... (cont.)

how to I replace a 39-393 operator. any instructions? Thanks

HelloI am looking for the appropriate top sash guide to fit single pane windows. I looked at the web site parts pages and did not readily find what I believe I need to replace broken top sash guides. Attached is a picture of what I'm hoping to find and order.1 3/4 in long x 3/4in wide top piecebotto ... (cont.)

Hello, we are looking for this part for a door. We havent had any luck identifying this part for our customer, this is the locking guts for an atrium door. I was hoping you guys could help?!

The plastic roller that holds the spring and rope is broken, so you have the parts to replace it? Thanks

I'm missing the strike plates for my screens and cannot seem to find the correct one to replace them.

2 pieces, assembled on top of each other. Screws are threaded into a metal jamb. Hole separation is about 2 1/8". Length 2 3/4". Width 1 1/4". Writing looks like Jernes or Ternes xxxDIFRAME, Industry, CA Thank You! I cannot find a replacement.

I am looking for replacement parts for mirror closet door guides roller and top and bottom track. The only numbers I found are on the roller- Del Mar 448-3.The nylon roller is 1 1/4 in. Dia.

Hello, As you can see, I purchased the S140-10 quick tilt single. I ambwriting because I need to order 2 5 pounds of similar nature and 2 2 pounds of a similar nature. However, I need the coil to extend with constant force up to 32 inches. The one I have does not extend to that length. If possible ... (cont.)

Need to know if you have windows handle

I have 5 windows that need new balances2 = 27 1/2 x 9/16 plastic 1 1/6 STAMPED 274 1 = 30 9/16 X 9/16 Plastic 1 1/16 STAMPED 304 2 = approx 24" (cant get window out) assuming width & plastic same STAMPED 2430NEED 10 total balances but not sure which ones I need. Thank you!Please call me if you ... (cont.)

Vinyl sliding window latch/ lock