Viewing all customer Discussions for:

Other

1 3/4" long 1" high 3/4" wide 1 1/8" wheel

The window is about 2007, with 3 horizontal window panes each lift-up and open with the crank This unit measures appprox. 4 5.8 inches long There is a top center screw hole but no bottom screw hole. The thread on the crank handle is gone. You have many similar crank units, but all have bot ... (cont.)

Looking to replace locking mechanisms in the images in attachment.

This is part of a of a pulley system on a sash balancer

Hello!! The corner is 1/4" by less then the normal 3/4". I purchased ones with pull tabs 1/4" but to thick for frame & seems to be about 1/8 to wide for about 1/4 inch to much for screen to fit back in window properly.Thank you. I need help (Suggested 95-23) The 7/16 needs to be 1/4" I ... (cont.)

I attempted to install this mortise lock (83-112) for my screen door. However I found out that the lock bumps up against the (4) mounting screws for the door pull. Appears there is only about 1" to 1-1/8" clearance for the lock to slide into the screen door frame. Can you screw right into the lock o ... (cont.)

We are needing a replacement lock for a patio door. We ordered this door from Empire Pacific Windows whom are no longer in business. The door is listed as a Vinyl Series 4250, White, OXPD, Call Size 6068, Dual Glaze Lo-E, Argon. (hope this is helpful) I attached some photos of the lock we need. ... (cont.)

Unable to locate locally

This is from a window sash locking latch. Basically its a decorative cover that snaps into the window. The crank is stamped with "Truth Hardware" I need 6 of these. The window glass is not stamped with a manufacture. estimated at least 15 year old wood windows.

Hello, Need help with a replacement operator shaft & operator cover for a hinged casement window. Did not attempt to open the window in case I would not be able to close it. My client believes this is an Andersen window like from the early 80's. Please see attached photos. Thank you in advance ... (cont.)

Dear sirs I need cylinder shown above handles are still goodLarry

I have Certainteed single hung tilt in windows. The pivot bar has come out of the pivot shoe and won't go back in. The pivot shoe is locked at the bottom of the sash channel. I don't see any coil spring. Should there be a coil spring attached to th3 pivot shoe?

I need several left and right to renovate several windows

Trying to replacement weather stripping

I am missing a handle on one of my peach tree windows. I think the color is called "driftwood" but I can't find the part. Any ideas?

this is a neo angle shower adn we are looking to replace the sweep for the customer. Can you identify and give me a price on the sweep.

Seeking for Sliding screen door wheels and handles 1-3/4 inches to (1-7/8 inches includes little metal part ) upper wheel is 4/4 inch with about 3/8 inch screw Handle is 4 inches top to bottom

The door is 24.5"wide by 71" I think it's from 1972 era

Could you give me a match for the window handels pictured? Thank you.

It seems like the only window crank that you have that would fit. It is approximately 5 in high I don't have a measuring tape so I can't tell you exactly