Viewing all customer Discussions for:

Other

I'm all my Pella window screens and believe I have the right corners identified (95-181). Do you recommend that I also replace the spline in these 35-year-old windows or can I reuse the spine? The existing spline is not what I would consider foam as it does not significantly compressed under finger ... (cont.)

Do you have replacement parts for this tilt window latch?

I am looking for 2 of these window springs.

Hello, I was wondering if you could help me identify the issue with this window? I believe the problem is a broken window channel balance. Please let me know if this is accurate or not. I have not attempted to open the window as I am afraid it might get stuck.

Looking to replace parts for windows installed in 1992

Measurements, 1 1/8 W x 3/4 D x 36 L; track opening to except pin is about 3/8 W

I would like to know the best replacement for my hinges pictured below and where I can purchase them. Thanks, Dan

Need to replace female window grommet allows for installation of window screen.

These rollers just slip or insert into the bottom of the hole on the screen door. I have four doors so I would need 8. I can send measurements if you need them or additional pictures.

Can't find any markings

Two window crank handles 2 left window locks 2 right window locks

7/8ths window lock

I have a Sliding screen door across the opening of my garage. The door panels use what appears to be a window sash lock to "seal" the panels. I need to replace one of those locks. The lock appears to be similar to the TRACO "Sweep and Sash lock" Model 50-603W. However, that the footprint of that ... (cont.)

I have tried to find the right replacement lock, and I am unable to. Can you help me with this?

Lock is for an up and down slide bar.

The original is broken. The first picture is what it's supposed to look like.

Hello, I'm looking to replace a broken block and tackle window balance. I found your site by googling PAT #6598264. The stamped marking on the metal is 25 4 and the metal rod measures 25 5/8".

30" length of metal.

Dear Swisco Helpline, Our right door (coming in from outside) is tilted due to top pivot (also bottom) being rusted. We are trying to purchase replacement parts and I am not sure which one to purchase. The original parts: bottom is about 2.2" height, top 2.8" and middle 2.8". Would you please gui ... (cont.)

The place where I bought my double hung widows from discount windows hawaii no long has this type of balance the windows will will not close probably it slammed down and I'm worried for my small grandkids getting hurt. Thank you Dale H.