Viewing all customer Discussions for:

Other

These are the rollers on some 1940's scratch-made cabinets in my house. I have replicated the style of construction in some new cabinets. I am trying to find this type of roller to complete the project. there are 7 new drawers. each would require one of the center rollers mounted to the drawer i ... (cont.)

looking for handle/lock assembly: Canadian Patent #919213, patented 1973, Patent #3596954. can you provide me with a degree of certainty a replacement part order Number Please. Or do you need photos be sure?

Its an old outside security lock door. I don't have the serial number for the door but on the lock itself is says MARKS. Have a picture of serial numbers from the fiberglass for the door. Thanks.

Hi! Our 20 Caradco replacement windows are 25 or so years old and now require full weather stripping replacement. The windows measure approximately 24"x 56".Can you help with this project?Ron

I need 2 items 1. sliding screen door wiper. 1 7/16" wide that fits into a 1/2" wide channel with a 5/16 opening. See strip photo 2. Weather stripping with a 3/8 wide channel with a 3/16 opening

I need a key lock for this door. Could you please recommend which one of your locks will fit this door handle.

Thanks for your help!! 30 inches long stamped with 29 3 HX CMC 11 not sure of manufacturer, but it was installed in 2004 also : i have one window that is 59 x 36, and two windows that are 59 x 51. my question is would both sized windows use the same balances??

lost a screen door adjustment screw and I need a replacement. The screw looks like your 84-502 however my screws are 11/64 inch diameter by 1/2 inch long. The holes the screws go into look deep enough where 1 inch would work; the only question is the diameter. What do you think? Thanks! ... (cont.)

Needing the inside piece of the door handle/lock mechanism.

Full name: ran Coil balance series: S210 Sash-weight: 40 Coil-stamp: Quantity: 10

Rollers for sunroom door Pictures with measurements attached

I found you guys on the internet I can believe you may have what I'm looking for I need two sets of ballast 2540BS1Please find attached pictures of what I have Thank you John

I'm looking for parts for my Certainteed windows they were installed in 2010 I need balances latches and a few other parts.

Hello, I'm looking for the replacement parts in the included picture. They are the top plastic cap on the window that captures the top of the balance spring in the window frame, and its associated square drive screw. I would also like to order the plastic guides (four per window) that keep the metal ... (cont.)

I need 4 tilt balances and 3 sash pivot bars. Can you please help me pick out the correct ones?

On wood casement windows installed in the early 60's. Also looking for seal material !

Trying to help a neighbor replace her sliding glass door handle set. what is shown is some half baked attempt to get a handle on there. it doesnt really work or lock. Can you determine what I need to replace the original set based on what i have sent you? Will you need more pics? ... (cont.)

Looking for a set of Pella 4" with 5/8 radius spring hinge - set of 3 in brass. House was built in 1996 if that helps with originally door.

These small plastic parts are on either side of the window frame of what I believe are PGT single-hung windows. Several have broken off. Can you tell me what they are and if they are necessary? If so, can they be replaced? Thank you for your help. Photo is of front and back of one of the plastic pie ... (cont.)

Looking for this patio slider handle assembly but in a white finish