Viewing all customer Discussions for:

Other

It's plastic Little over 38" long 1st plc , is installed piece pointed out by the pencil, second photo is I'm holding up a old piece or the new police needs to go and the third picture it's another one shows where it goes covering the spiral balance

Hi, I am trying to remove my window (one pane is broken and I am getting it repaired) but i am finding that the pivot bar (when window is tilted in at 90 degrees to floor) will not budge from the pivot lock shoe. it seems frozen in place (not surprising since the window is about 20 years old). an ... (cont.)

Can you tell me if you have this item in stock. It is a commercial window latch that requires an allen wrench.

Looking for replacement sash balance. Not sure which numbers are relevant. See picture

This is a rear dresser drawer guide, about 20 years old. I couldn't get all measurements as the tips were broken off. Thanks for your help in identifying the part number, so I can order a few. Ken

Hello - i have an old Pella sliding door that i was hoping to get new hardware for. Inside lock is separate from the handle. Pictures attached. Would prefer in brushed nickel vs. brass. Thank you, Joe

I WAS TOLD THIS WAS APROX 20 YRS OLD. WE ARE TRING TO GET A REPLACEMENT

have no idea how old this is. bought a condo and the crank appears to be stripped. cannot identify so that i may get it replaced/repaired

Hi What is the part number for the Tilt latch for attached vinyl window? Thanks

My original sliding door was made by "Cross" put in 1976. I need rollers that will fit this particular door. Thank you

I have a JEeldwen patio door. The screen rollers are rusted. I need new rollers. Can I get the parts through you and what size or number are they part number?

passage lock with 2" backset (for atrium door) Prefer lever style, but knob is acceptable.

IMG_6556.jpg

Looking for inch and one quarter window glaze . The window uses BSI 34B balancer with the 15-169 snap-lock pivot shoe if that helps.Thank you .Ray

The channel length is 32 5/8 inches. The stamp is 32 5 I need 2 balances

I was given a new milgard casment window Tuscany, but I am missing the Folding Nesting Operator handle part. After looking at your website I am looking for help identifying the replacement handle.

This patio door roller looks like catalog # 81-182. Please review pics and confirm.

C58 6#28 10/80 11600-2 Need 2 to start with

Rubber is the vertical seal for a rear sliding window in an 80' GM pickup. I am open to a brush seal if there is one that would slide into the aluminum track and be of comparable height. Thanks

I'm trying to find tilt latches for Jeld-Wen, they are internal latches with the number 13932 on the body and 14164 on the spring-loaded portion. can you provide any direction? These are Premium Vinyl DH from 2013 or so. Thanks!