Viewing all customer Discussions for:

Other

I need advice on T spline on a screened door with fiberglass screen that I'm replacing. It measures both directions at a little over 4/16 it looks to me. Would that be your 5/32 product ? Can round spline be used instead? Do you need a tool different than the normal rolling spline tool ? ... (cont.)

Bought a 20yr old house missing 4 of these locks. Cant find them anywhere P/N: 30211 P/N: 30396

Allen Steven's Corp

Attached you find a photo of my old lockset and your lockset. If you have anything that will fit my door frame, that would be great. Even better, if I can use my old lockset and your brand new shiny handles and trim plates, that would be great.

I'm thinking of the series 765-27 inches long. My sash weighs 20 pounds. How do I attach the balance to the shoe? And what pivot bar do I need? I need four.

One of our windows fell out because the stripping was never installed. We didn't notice until recently, the house was built 3 years ago. I included a photo of a window with stripping in addition to the window without. The window is a Gemply brand and measures 34"x 45.5". Can you tell which stripping ... (cont.)

I will need the entire right hand casement crank assembly. I just bought home - it was built in 1983 so I don't know how to replace it. Would you have anything comparable and what is price if you do? Thanks.

Looking for replacement assembly to match this product. Current one stops moving while cranking in and out

Hi I have an older sliding glass door and want to install an exterior keyed lock as you showed in your video. Do you have a certain one that you recommend?

Good afternoon, Thank you in advance for your assistance. I need a replacement crank and a window latch for a casement window. Here is some additional information: Multipoint lock with 4 latches Window measures 71.5" x 32" Window opens right Latch opening is 4 3/8" x ½" depth to track connector is ... (cont.)

Hi, Can we get this part from you? There were no labels or identifying marks on the window. The window size is 37-1/2" x 17"

Would you have a closet door roller like the attached? Thanks

I have a customer looking for either a replacement crank for a casement unitor the whole part if that is the only way you sell it. It says "truth" onthe part. Is this something you can help me with.Thank youJoanneMethow Valley Lumber

How do you replace a window coil without a cutout? I don't see how to get the broken pieces out of the frame.

Caps the bottom of windows.It is foamy to the touch under the bottom of the windows.It is 3/8 inches deep on the bottom and goes up 1/2 inch onto the outside;The 1/2-inch on the outside is what has deteriorated

Hello, I'm hoping to add an outside lock to this Paradigm slider. I've attached photos and info off the door. Any thoughts would be greatly appreciated.

Hello! I need to replace two of these--one on each side for the upper sash. The window has no brand or number that I can locate. Any help identifying the right replacement would be appreciated. Thanks in advance!

Hi, My Customer has an MI window that has both tilt locks and balances failed. Color looks to be Almond. Thanks, Stan

It is for an screen door. The door width on it is 42 inches. It's a handicap door.

mounting holes are 3 3/4 a part. if you stock a brown color would be great