Viewing all customer Discussions for:

Other

Do you have a hinge that will work for these? This is a picture of a replacement I used two years ago. I would prefer Stainless as it is a ocean front home and the original painted truth brand rust out after about 5 years. Your web site shows 10' and 14" -is it possible to go slightly larger or sm ... (cont.)

Trying to identify the replacement part for the crank mechanism on a jalousie window. The crank comes off when you close the window.

Balance is stuck in up position. I am unable to push it down to clip. Windows will not budge. Please advise.

I need the size in the middle that does not overhang You sent me the larger ones on each side. They overhang on the ends and the sides, and will not fit. I'm a previous customer who has purchased channel balances and 1/2" top sash guides before (18-036).

Where can I find and buy the triple coil system for simonton widows series 40-06/40-17

Require 4

Hi,I'm not sure if that's the correct name of this, and I do realize that the parts are still in the window frame- think it's a vinyl window- but can this be replaced? If so, what would I need to purchase to replace the broken one, how would I identify the part?Please help me, as this is in my basem ... (cont.)

We have a house built in 1984 with MW Dual pane double hung windows. All windows have retained their seal.I need to replace 14 springs in the jam liner:I will need 4 for window size 27 7/8 inches in height and 35 1/2 inches wide.I will need 10 for window size 39 3/4 inches in height and 39 3/4 inch ... (cont.)

My tenant has somehow removed the part that holds my windows up when raised. I am not sure of the name of the part we need but it has a 5 in an oval on top.

Hello, Please help me identify this tilt latch. Thank you.

1 3/4" x 1/2" wide one roller The length doesn't include the tips on each end

Hello, do you happen to know what this piece would be? It is to the bottom part of a window.

1/2" single hung non tilt Millard window balance 14-6 JE5 CMC 45

Can you assist with this glazing bead ID? The face is ~1.1" aside from that the rear return appears to be standard as compared to a few other beadings offered. Please let me know. Thanks!

Hello! Looking for this roller to replace on my cabinet. Unable to locate this older part. Hope to hear back from you! Thanks Grant

Help I need both sides no idea what kind of window it is

Trying to replace this DFA latch and lockset. Prefer a bright Nickle finish.

These are the hand latches I'm needing. If you could please help me you would be much appreciated. 91-026 did not fit.Can you please tell me what hand latches to order, left and right side?

Looking for a replacement part upper window of double hung window, Winged pivot bar and plastic housing Plastic housing have A-4. 853 stamped into it