Viewing all customer Discussions for:

Other

hello I have a channel balancer that is 21" long and is stamped with 20E which one do I order.

I have a channel balance to replace. The imprint on it 25S. It's a tilt out window. Is this enough information to tell me which one to order? Thank You!Robin

Looking for 5 to 10 nut and plastic bolts that attach slim shade to window and allow cords to pass through

I need one spiral spring balance: 26" long x 9/16" diameter tube Also need 26" brush weatherstripping: 3/16" plastic width and 3/16" overall height.

To whom it may concern, I'm looking to replace the part pictured below. It's the slider mechanism from a glass patio window, and dates to the 1980s. The part is marked "Allen Stevens Corp" "Woodside, N. Y.", with a circle that has the numbers "60" over "49" in it. The piece with the wheel a ... (cont.)

Hello,I have cabinets that are approximately 30 years old. The drawers have Accuride drawer slides. The plastic back brackets are broken. I am hoping you might be able to help me find replacement brackets. I am trying to find back brackets for 4 drawers, 8 total brackets, 4 left and 4 right. I a ... (cont.)

Good afternoon I am attempting to locate a pair of window tilt locks. They are made of plastic and are surface mounted.

Channel width 1/2". Channel length 29".

hello, can you tell me please if you have this coil? thank you

I don't know the type for replacement. Full overlay, what degree? 155? Part1986600122

Hello, We are searfching for these specially shapped edge hinges. Would you be able to help us? Thanks Kind Regards Martin

Hey there, I need new balances for these windows. Is there any how you guys can help me out which ones I need for this type of window. They're Pella windows. Thank you!

Awning windows used throughout 1954 ranch house located in Savannah Ga. Any idea who the manufacturer of the windows where? Many of the cranks are stripped out and will not operate the window to open or close.

Do you have this piece? It's a single handle for two sides, left and right windows next to each other. Thanks,

Do you have these Handles/pulls?

Not sure what I should do. There is no slot to take out the spring. I weighed the window and it is 14 lbs. any ideas at would be appreciated. I really don't want to cut the window to get the sping out but i am not sure what else to do

Markings - NL BSI 34CDimensions:Length - 34"width - 9/16"Depth - 9/16"I have images available if you need them.Thank you,Patrick

Needs to know what parts do I need. Thanks Jeld-wen windows

This a window crank taken out a PGT window. The only markings are 41010B on 1 arm and I believe 3180 on the other. Also, says made in America.

Hello, The locking mechanism is tough to function. I have to partially remove the key to get it to open so would like to replace the lock. I cant find a model number on the door or anything so helping the pics can help.