Viewing all customer Discussions for:

Other

Looking for this part for what looks like either a storm window or mobile home window. Need both sides.

Hey there, I can't identify this tilt bar from your website. I am also having difficulty removing the part. Here are three pictures.

Hi Folks, A client has some old vinyls that I can't identify because the id tag is not readable. The coils and shoes are beyond operation as well. Help please?

Channel balance series: S700 Channel length: 51 Channel stamp: Quantity: 2

Trying to find replacement latch This is a single hung vinyl window Unfortunately there is no aama sticker

I need hardware replacement for my awning window. Please help me find correct parts.

When crank is turned the window opens. When trying to close the crank comes out.

Hi, The pivot bars have rusted out on my windows. (Located near to beach) Questions: 1. Can you please advise the correct replacement parts if possible based on the photos and below measurements? 2. Based on the condition of the pivot shoe and broken / rusted piece of the pivot shoe in the slot - ... (cont.)

I'm looking for the replacement cranks for a millguard window. I need 2 left hand and 1 right hand. Thanks

AR-Casement 2600 Type C-SSV Code AMX-K-9 Window dual arm casement operator. crank opening/closing mechanism

Latch will not latch. In the photos it is as open as it can get? the latch that is. I did find a 3 digit number it is 985. The measurements Look like it is a 82-218. My house is paid for and there's a possibility I may be selling it,. I'm sure the new owners would prefer to have a actual mechanica ... (cont.)

This is a picture of an unbroken part, but many were broken when older vinyl windows,(think boat window vinyl or vinyl tablecloth) were torn off by Hurricane Ian. Shredded vinyl can be replaced but I can't find this part to replace the broken ones. I'm not sure what it is called so don't know how to ... (cont.)

In need of brushed nickel or brushed aluminum door sweep for andersen storm door. Its 36 x 1 U-shaped and it's 1 inch high. Thank you. Weezie

Hi lock Expert- Please see if you can help me find a replacement window lock. The lock needs to be flush with the non sliding door.

1 3/4" long 1" high 3/4" wide 1 1/8" wheel

The window is about 2007, with 3 horizontal window panes each lift-up and open with the crank This unit measures appprox. 4 5.8 inches long There is a top center screw hole but no bottom screw hole. The thread on the crank handle is gone. You have many similar crank units, but all have bot ... (cont.)

Looking to replace locking mechanisms in the images in attachment.

This is part of a of a pulley system on a sash balancer

Hello!! The corner is 1/4" by less then the normal 3/4". I purchased ones with pull tabs 1/4" but to thick for frame & seems to be about 1/8 to wide for about 1/4 inch to much for screen to fit back in window properly.Thank you. I need help (Suggested 95-23) The 7/16 needs to be 1/4" I ... (cont.)

I attempted to install this mortise lock (83-112) for my screen door. However I found out that the lock bumps up against the (4) mounting screws for the door pull. Appears there is only about 1" to 1-1/8" clearance for the lock to slide into the screen door frame. Can you screw right into the lock o ... (cont.)