Viewing all customer Discussions for:

Other

Part numbers 11195 and 11196

I'm renovating a 1932 home and I'm trying to keep all the original doors/hardware, but I need lever handles with a square 1/4 inch shaft hole and set pin. Help.. Thank you and have an amazing day

Need help identifying the window pivot shoe pictured. It has the number 4610108 stamped on it but it looks like your item #15-216. It's not an exact match. The window is an obsolete Pacesetter vinyl window. The balance is stamped 30G. The sash weighs 80#.

Q LON foam-filled weather strip for a roto casement window (strip is in both frame and window). I'm not sure if it's the original. It needs to be replaced because there is a draft coming through where it has worn down.

I need some clips to hold my screen in. I will send you a picture of the ones I have. I hope you can help me.

Hello, I was wondering if you can help me finding the correct Cam I need. Please see attachments. Thank you!

I have several double coil pivot shoes and one single coil pivot shoe which have broken on my Alside double hung vinyl windows. I don't know if the pivot shoes can be replaced without replacing the attached coil(s). Whatever is needed, I need to find the part(s) to fit my windows. Thank you for any ... (cont.)

I am trying to find a replacement corner for some screenwork we are performing at Columbine Ace Hardware in Littleton, CO. Any assistance you may be able to provide will be greatly appreciated. R/ Jim

Need vent cover and control arm.

I need help to identify the right handle set and mortise lock for my glass door. I spoke with a representative a few minutes ago, she said to send the pictures with measurements. I don't have picture of the mortise because it fell inside the glass door. The last 4 pictures are old Here the two item ... (cont.)

Jeldwen casement window 25 x 71 needs new operating arm per attached photo

RONTHOR REISS REAR DRAWER SLIDER 40 28

I need to identify correct Window Weather Pile stripping for my Vinal Windows. The pictures are attached, The pile is full of dirt and dust and seems matted down.Also I need advice how to remove the pile from these channels they seem imbedded. Do I need to cut out one side so I can pull out with nee ... (cont.)

Clips for double hung windows

Trying to locate replacement snap-in glazing for alum window Capco?? Photo attached. 1 in. width.

The 10-216 lower shower door guide. Once installed should they stay in place at opposite ends of the door? Do they need to be glued in place so they stay in place so the door slides on the track. My new pieces free float causing the door to tilt and not slide

Attached are some photos of a mortise lock that I pulled out of a roll-up shutter L 8.75" X H 1.50" X W .937"There are no numbers indicating a part number or a manufacture. Can you help to locate a replacement part?At your service.Thank You,John

I need four of the channel balances mark 29-6 and I need eight of the channel balances marked 34-9. I also need eight of the small plastic pieces of the last picture enclosed

Hello My name is Ken I need both LH & RH vertical rollera. Isee no name or numbers on window or rollers, but here are the measurements. The roller has 1 hole in the top-- two holes in the bottom.Overall length-5-3/4in . width-2in.c-c top hole -bottom hole-5-1/4 in, ( not aligned) c-c bottom hol ... (cont.)

I am looking to replace a few broken latches these are in older aluminum windows