Viewing all customer Discussions for:

Other

Window was made by Thermal Industries. Need replacement spring assembly. White plastic part is what broke. Upper sash.

I need a couple of dozen

1/8 x 3 inches curved with 1/8 x 1/4 "tab" that slides into corner. Spring pushes against window jamb and holds screen in position.

I have a pella French door I believe the serial # is Pella -0700-DCCIFAI1Z2-058E081IWHT-525S-NFRC, I am looking for the entire locking mechanism from the floor to the top including the lock. Possibly a proline/450 series 3 point lock, 81 Proline 1991-4/15 Any help would be greatly appreciated. Th ... (cont.)

I'm looking for the pivot show for my Alside windows. Attached are the pictures of the show. I need both the left and right show.

Please help identify the part that needs replacement. We have a Jeld-Wen vinyl sliding patio door that was purchased in Spring 2008. Picture #2 shows how the top latch does not protrude far enough to engage without forcing it. Picture #3 is my best attempt to indicate the size since I don't know ... (cont.)

Vertical Glazing Bead's have a falling out in this window and I need to replace them. Not sure what size to buy. Any help would be appreciated. See pictures below.

Both sides of the lower window single coil springs broke. The brake shoe is 2 1/4" long X 1 1/4" wide. The connection of the single coil is a single screw attachment into the track above the lower window when the window is in the down position. I can cut one side of the track rail to get the brake s ... (cont.)

I am looking for the left side tilt button for a silver line window the sides are smooth. The pictures with two show the size difference and the bumps on the side of the in correct part.

I have just recently purchased a house with a Silverline window in an upstairs bathroom that doesn't work, needs a new crank assembly. I have attached a picture of the warranty label and the crank in the window. I need the whole assembly because the handle is stripped.

Can you verified the part number please? Thank you.

Bolt latch handle is broken. The bolt is about 20 in from top of door. The face is 4/14 by 1/14, white.

I am looking for a replacement window operator for a Milgard awning window. Identical to the what is shown on the attached picture. The arms are stainless steel.

Our window needs this part . Do you have it? Or do you need another picture with measurements?

Do you have this balance in stock? Kinco series tw-1 sh Balance had the number 3130. 36" Lengths and 29" Lengths

need 10 feet of Marvin weatherstripping for the top of a double hung window. picture is broken off the interlocking. this attached to the parting stop on top of the window frame

We need the replacement parts for cranks and Handles.

Hello!We have acquired a 1976 Thomasville dresser. All the drawers fall out when you open them. With difficulty we get the a drawer to get into the rail ? then it doesn't close all the way. Do we need to replace all of them or are we doing something wrong?Thank you!Lori

Looking for the top lh & rh tilt latches for 2 windows.the only part number I can find are- F0251 pfshw 129.375 x 29.063 I need 4 sets WHITE- F0066 pfshw 129.375 x 29.063 I need 2 sets WHITEElton

I am looking for a replacement for a narrow stile lockset with a brass lever handle similar to the Wright 40-049 narrow stile 40-049 with hook or pivot dead bolt