Viewing all customer Discussions for:

Other

I would like to obtain a replacement latch, the height is 7/8 inches, the other dimensions are one one of the photos. On the bottom is a large K, 75, and a Pat.# 5.139.291. Thank you for your assistance.

where can i buy this hinge l need a couple dozen with spring

I need to replace one of my Thomasville center Mount drawer glides from a circa 1980s chest of drawers. I've been reading your posts that recommend the 32-053 as a suitable replacement. Does the 32-053 have a system in place to not allow the drawer to just pull out during normal use? ... (cont.)

(2) of the 14-4 stamped BSI RN TJ 15" metal channel. (4) of the 26-3 stamped BSI RN TJ 27" metal channel. I believe they are the BSI extended range with the metal clips.

Seeking replacement tilt latches for vinyl windows. There are no numbers or manufacturer names on the parts or the windows. Possible Milgard 30 yrs old. I need 6 pair, please

Looking for window sash lift spring. Part # is P A2740. Two please.

Hi, I am trying to find this tilt latch and hope you can help. Thanks. Dave

What would be the current replacement part number for this balance.Thank You Tony

Dimensions: length 3 3/4" includes adjustment screw Width 11/16 Height 1 3/4" fully retracted (lowest adjustment) Please advise me if you have a suitable replacement (heavy door) Thank you for your help!

I need 4 corners for a window screen the screen frame is 3/8" white Square cut corners are 3/4" the plastic pieces that insert in the frame are between 5/16 and 3/8" thick (I also have a question: I can't pull out the plastic pieces from the top frame (the metal tension arches are in these corner ... (cont.)

stamped on the top of the operator are the following 0-9400A-1 Right it is a double arm unit.

These are from a milgard window installed in 2004 It's clearly a half in wide 30 inch long And I think either an s380 or s385 I can't tell the difference between the bottom shoes Can you tell from these photos?

this piece locks the window arm to the casement

Hi, hope you'll be able to help me to find replacement for that type of balance. 27 inches length without plastic parts. Thank you very much, Nick

Window brand us unknown 2-1/4 hole spacing, tounge 1/2 projection and 1/2 wide Total length 2-3/4 width 3/4

I would like to confirm that the S770-28 with the 28E strength is the correct window balancer to order. The primary difference between the old balancer (see pictures) and your S770-28 is the old balancer attaches with an S-clip versus a screw. I would also like to know whether you recommend also r ... (cont.)

Looking for Screen Door Bottom Slide in rubber weather strips

Looking for one window balance top has a clip that goes in hole at top of window bottom shoe measures 1 inch. Stamped on face 28C Greg

My windows are old and that cover does not seem to match the ones I have, see attached photo of what I need. I need two right side covers and two left side covers

Markings on the part read: 27 5 GT CMC 2