Viewing all customer Discussions for:

Weatherization

Can you point me to the hole cover and the weather stripping for this window? I am trying to refresh some of my windows. This one is probably the worst as the pivot bar was totally rusted in there. The rest of the windows should be better.

Good day, I uploaded a drawing of a door sweep I'm trying to replace from a Norco inswing door. I have a blurry photo of it installed but I don't dare remove it to photograph it as it may not go back on well. I'll upload the photo as well. Let me know if I can provide you with more information. T ... (cont.)

I need some front door weather stripping that looks like this.Ted

My name is Harold (Larry). I am enclosing five photos of a window sash that has the bottom seal deteriorating. The seal strip slides into a shallow, narrow grove on the outside face of the sash. The sash is white vinyl. I don't know the manufacturer, but one photo shows the label on the edge of ... (cont.)

2 piece vertical door seal for 6? wood frame sliding glass door. Door was installed early 1994. The picture with the number is on the actual door. The plastic seal is approximately 77? long

Hi, I'm looking for some weather strip for my lanai doors. I can't locate a brand name so I don't have that to help us. I finally located a full piece to measure and come up with 3/8 x 3/16. I did send this same note to your general mailbox but added pictures to this request. Thanks, Jim ... (cont.)

My second email after finding video about measuring it 5/16 diameter and the part that goes in the track is degraded bu t I estimate it to be about 1/4 inch. It is 28 1/2 inches wide .

Need bottom seals for 7 windows,

Is the SWISCO 58-173 a replacement weatherstripping for a 30 year old Pella entry door. It seems to match up in most respects.

I am attempting to indentify weather seal for casement window from the attached pictures.

Attached is the weatherstrip from my window, can you please tell me which product matches it? Thanks, Paul

I need to replace the bubble seal(?) at the bottom of my Traco TR911 windows.Can you tell me which seal I need? Mine is crumbling so I couldn't get a very good picture. Hope the model # helps. Windows installed in 1998.

Replacing the two types of weatherstripping used on a Stanley "Sta-Tru" exterior door. I've attached a profile of both and the door ID label (if that's of any use). Please note the one weatherstripping has a magnetic material. Thanks!

The 3rd pic shows the plastic stripping. The middle pic shows it installed in the window. It goes at the top, bottom & both sides. The first pic shows the window without the weather stripping. We were told by a local glass company to just caulk the window. We don't like that idea. The sun has ... (cont.)

weather stripping on metal garage door into house. Installed in 1988 / 89 Stanley door

The marking on the door says "legance 3 patio door, type DDSG, code TRI - K - 36". The part is basically a rubber T that slides into the bottom of the door frame with the long leg fitting into a groove in the door frame.

I am looking for a storm door sweep like the one pictured above. Sorry that the picture it upside down. The measurements are with of top spline is 3/8", length of sweep flaps including spline is 11/16". Thanks for any help ypu can provide.

We need replacement weatherstrip for Gorrell vinyl casement Windows. There is printed Q-LON on the weather strip The weatherstripping has a vinyl covered T shaped , rigid plastic part that slides into a 1/8 inch groove along the outer edge of the frame surrounding the glass. The slide in tang ... (cont.)

Window manufacturer windowmaster vinyl

My roll out windows trim has hardened and is falling off the window. Windows were installed during construction 30 years ago. High end construction by builder. Unable to locate window mgf.