Viewing all customer Discussions for:

Weatherization

Hello. My windows are over 25 years old. I don't know the manufacturer. The weatherstripping could not have been very high even when new. I suspect that 1/8" deep might be too much. Am I stuck?

Our house was built in 1980, sliding door is original and I believe it be a wooden Pella door. The door is in decent shape but the weatherstripping could use replacing. Can you help me identify a replacement option that will work?

Old weatherstrip from 1970's steel door no markings. Need to know if you have any product that would work for weatherstripping on this really heavy steel storm door. Could care less what"design" it is.. mostly interested in the t shaped dimension that fits in groove .

Attached are two pictures of gasket from crank out window These are outer weather seal

I am looking for a replacement seal for some old windows. They have 1998 stickers on them. Not sure the brand. I replaced the wool pile already, I used the zipper pile because it can't be slid in. This bubble seal is disintegrating so I know it won't come out in one piece. A few windows are missin ... (cont.)

I need to replace this bubble like weather stripping on the bottom of my window sash . I've included the warranty label as this is the only info I have about the windows.

Was wondering if you could help me match up this weatherstripping for my door, attached are pics , one is from your website which I think matches, please let me know if you think it's a good match Thank you Pat

Could use some assistance in ordering weather strip to replace current on two separate metal doors. See photos

I need these weatherstripping for late 70s Pella sliding door and casement windows. First picture is the window insulation. It's 5/16 wide and maybe 3/16 deep. The door strip is plastic and it's u shaped. The face that goes against the door is 1/4. Thanks

Hello! I'm looking to replace strips for 2 doors. They have an accordian appearance on outside edge and have black plastic ribs inside the folds. They appear to stick onto the door stop, but I can't see if there's a groove in the wood for them to stick into. They appear to be substantial and stron ... (cont.)

I'm looking for instructions on how to install part 58-184.

Weather stripping

champion windows, no part numbers, bubble seal,

Shown with a sample of a commonly-available (Lowes, Home Depot, Ace) foam strip. The foam is way too thick so the door won't close, even if I cut off the tabs on the kerf so it fits in the frame.

Looking to replace the Kurf bottom seal on these windows.

Hi looking for t slot replacement for my windows. Appears to be 7/8" total height, the slot is 3/16" and the bulb is 3/8". I will also need 3/16 x1/4 white pile. Thank you, Duane

Picture is cross-section of window seal. Located on top sash along the bottom, facing inside. Fairly rigid yet flexible. No markings. No numbers. Ghost part. ;)

Can I get a specification sheet for this seals?

1/4kerf x 1/4 bulb

Hi, I need to replace the window weather striping. Its base is 6 mm in length and height is 5-7 mm. It has center line in between and pile on both side. I am not sure which exact one I should get to replace these ones. Please suggest.