Viewing all customer Discussions for:

Weatherization

Trying to find a replacement seal (between side of door and stationary glass) for a Pella patio door. Don't know the model or serial number of the door, info went with previous owner. Current seal leaks like a sieve. Couldn't get photos to attach to t his message, but seal is bulb-shaped with dia ... (cont.)

Hi, I have added 2 photos of my main door rubber seal. Please check if you have the same and inform me. Regards

Attached are some photos of weatherstripping that I'm trying to replace. The windows are 30 years old. I believe they are Weather Shield brand. The snap in ledge of piece is about 3/16" and the seal part is about 5/16" measuring from the longest points of the oval. Any guidance would be appreciate ... (cont.)

I need 24 ft of this example seal

Can't find any markings at all. I do know they are vinyl replacement windows that say Permanent Temp in a corner of the glass.Need the weather stripping.Thank you. Tracy

Is this your 58-127 Pile Weatherstripping - If so How Long does it come?

Is this your 58-182.187 T-Slot Fome Filled Bulb Weatherseal

I'm looking for the lower T-slot bubble seal and possibly for lift pins for some windows which I believe are Jeld-Wen dating back to 2003. The lift pin itself is 1/2" long by 0.050" diameter. The base portion is 0.440" diameter. This pin appears to screw into the window's extrusion. If you have ... (cont.)

Need to replace approx 190 inches of stripping shown in photo: two 80-inch pieces and one 30-inch. Width of strip is 7/8 inch. Depth of insert is 1/4 inch. Depth of bubble is 5/8 inch.

Hi, do you carry anything similar to this weatherstripping that II need to replace ? It iis used on the track of a sliding glass patio door?

Store front door single strip up front edge, single strip up back edge removable metal trim on door between. Aprox .5" gap between doors. Aprox 3/8" back of strip

Hi, looking at the bubble seals, which one can I use the replace what I have?I am looking to also increase the diameter by 1/8 for a better seal. The kerf is 1/4 tall, square base 1/8x1/8Thanks. Emanuil

Hello I have 2 casement windows that the weather stripping needs to be replaced as the previous home owner put in rope caulk in the channel where the original weather stripping was located. I am not able to locate the weather stripping at my local Home Depot the windows measure 27 x 36 inches I will ... (cont.)

I would need 50 feet. Thank you

Hello a have to replace this weather gaskets for a customer please get back to me as soon as possible just need someone to tell me the code of each gasket so I can Order, I believe they are Kolbe doors and need the complete set. Thanks Peter

will replacing the felt gaskets stop the leaking

I purchased WindowDepotUSA windows in 2007. It was manufactured by AccuWeld: which was bought out: but warranty and support issues: are not supported. I need to replace the weather stripping on two large sliding windows: it appears the stripping is "worn, twisted" and needs to be replaced. Without ... (cont.)

I am looking for the rubber seal that goes around k&k casement windows thank you Donald

This is an old storm door fin - not sure who made the door but it might be Larsen. Top is a "T" approx. 5/16" wide but it has 2 fins coming out from it, can't find a version of this anywhere. Let me know what you think.

0D0K0033. TFH 36 door sweep. Pella French Doors. 3 sets (2 doors each). Part number please