Viewing all customer Discussions for:

Weatherization

Hi Looking for both sorts of window seal. One is patio one is just a normal window. Both mDe in around 1965

The weatherstripping is installed in the threshold and seals against the bottom edge of the door

Looking for a slide in weather strips for the bottom of my windows. Any thoughts on my project

I need some weatherstrip that I can't find on your website. It appears to be gray wool pile, 1/2" x 1/8", but the flange that goes into a groove in the sash looks like a little Christmas tree. See photos, attached, edge view, side view.

Hi, I built this house in 1994 and have 5 Kinco Windows where the exterior rubber weather stripping has deteriorated; it resembles a windshield wiper piece of rubber with a ?-inch lip that sets into a channel on the lower exterior section of each window. These photos are taken from the outside. Seem ... (cont.)

1/2" from top of bubble to bottom of insert.

This is the seal on the sides of a window I'm replacing the worn seal on. It is a vertical window with the roll out handle on the bottom. The seal slip in the sides on window. Can't find them local anywhere. Needed asap.

Can you recommend a replacement stripping for my vinyl windows based on these photos? Looks like a tee slot with foam filled tube. Thank you.

Looking for a specific weather stripping It is a P style Part # 15171136 Part line 272070? Do not know if this is identifiable for you. width is 3/4" Need 220 feet

Trim is plactic and runs the whole length and width of the screen or glass insert. The trim is about 3/4" overall and the 9/32" wide of the retainer that goes into the slot of the door.

bottom seals on south side have dried and become brittle, they slide in/out, can I get a roll of the material to cut as needed to replace?

looking for jeld wen bottom weatherstip windows purchased from menards thanks tom daley was given your website from jeld wen they do not have replacement parts windows to old !?

Hi, do you have a replacement for this door slider insert? It need to be at least 77" long. Thank you in advance. Will Buyers

Hi, I am looking for 72 inches of this threshold gasket. Thank you

Hello,Your weatherstripping looks like our 58-171 bubble seal, but you'll need to compare yours to the dimensions on our product page to make sure that this will work for you. Thank you!

serial number stamped in door is 970905B, Weather strip on handle side of door comes out of the jamb when door is opened

Unfortunately there is no identifier or name on the door. I'll need approx. 70" of weather stripping.

Please find attached or suitable replacement. Thank you. Gary G

I can not find this weather strip kit anywhere because it is an eight foot exterior steel door. Please help.

Just ordered parts for a double hung window (order 1218173). I also need weather stripping for the bottom half. I looked at your selection, but am not sure. Sent some pictures. Hope you can help with a fit.