Viewing all customer Discussions for:

Weatherization

Replaced my windows in 2005 with vinyl double hung Windows with half screen. Noticed that my weatherstripping at bottom of window has deteriorated from weather. Where can I get replacement

I'm going to attempt to refurbish a couple of windows. I've been able to locate the proper cranks, but cannot find an easy match on the window seal. The attached photo shows a cross-section of the existing seal. Seems like most of my windows have this seal squished down flat and it's beginning to ... (cont.)

This seal is from my front door, original to the house built in 1984. I have searched every where but can't find anything that can replace it.

Just installed new replacement bottom sweep (Swissco part 58-162) in Forever View storm door. The sweep drags on cement when opening & closing door, making it difficult to open & close the door because of the resistance. Can anything be done to fix this? Thanks.

Pella 1G. 9.5mm

Can I get the "Fuzzy strip" for the track in the window. It looks to be about an 1/8" wide Thanks

Need to replace door sweeps on two sets of French doors 28 years old - 1 -3/4 inches wide Looks like nailed or glued - no channel Cannot identify brand of door Saw your link in Handyman Magazine HELP - I've looked everywhere!

The flange is 0.25" and the bulb is 5/16". No neck on flange. From a 1980s Atrium commercial door.

Wool Pile that appears to have a 9/32" width and 3/8" height (maybe eve 7/16" when it was new) with a center fin seal. This is for a Crestline sliding door.

I'm guess it is .187" x .250" wool pile.

The bulb-type weatherseal on these windows is falling apart. I believe your 3/16" T-slot foam-filled bulb weatherseal, PN 58-182, will be the correct replacement. Please review the attached pics and drawing to confirm this for me. The extrusion is a little different than that shown in your on-lin ... (cont.)

I have an older anderson PS11 GL Oper sliding glass door and need to replace the rollers which I understand as being PN 81-018. I also need to replace the weather seals on the door. The ones currently appear to be stapled on except for the ones that go on the door frame where the door meets the fram ... (cont.)

Tube is close to 5/16 and T is close to 2/16

Hi, I am needing to replace the weather stripping and the brush sweeps on these doors. I could not find any markings or information as to what brand the doors are on them. Could you please tell me if the 58-105 or 58-085 would be the weather stripping I would need? The door sweeps I need are brus ... (cont.)

I have weather shield casements circa 84. I've been trying to find weather striping for these, do you think you have any.

I have several LP casement windows( 1991 vintage) that need new weatherstripping. The profile is very close to the Kerf Bubble Mount Seal 5/16" (58-504) . However, I am not sure about the wall thickness on the bubble itself. Mine appears to be thinner, possibly 1/64" thick. Could you please ... (cont.)

Hello we have swing doors for which we need to purchase weatherproof seal / sweep striping. Any suggestions for you? We have the following doors : zz_SOHMD_36489 - Elison 3/0 6/8 LWP3 Double Acting Door w/9" 3 x14" lite

I am enclosing a photo of a piece of the weatherstripping I need to replace around 2 casement windows. The entire piece is only 1/2" wide. there are no identifying markers on the entire strip. I hope you can help...this has been a real challenge. I would appreciate any suggestions you can offe ... (cont.)

Looking to replace old weatherstripping. The plastic base is approximately 3/16" wide. The top portion that is foam filled is approximately 3 - 4/16" wide. The overall height, from the plastic base to the top portion is approximately 1/4" tall.

Hi, the vinyl sweep on my fairly new pella storm door has ripped, so I was hoping to find a replacement. The top of the "T" measures about 5/16",as close as I could tell. Do you have anything that might work? Thanks!