Viewing all customer Discussions for:

39-085 Crown Window Crank, LH

Hi Team, I live in south Flordia, house built in 1989. Majority of my windows has this type of crank. This one the handle broke. Can you assist in helping identifiy a replacment, and would you like any additional photos?

I need to replace the casing for one of the windows. We use the crank to open, but it skips. I believe it's something in the mechanism of the casing. Windows were installed in 1971

Looking for left and right side operators. Operator to window hole is none threaded and appears to be a 3/8" hole. 1st vertical hole seems to be 4-1/2" spacing 2nd vertical offset hole is 5-1/8" spacing Bottom hole distance seems to be 1-3/8" Thank you, Jason W

Replacement

What is the equivalent window operator in your catalog to buy? Thank you

i need to replace the part pictured

All measurements match the VE Anderson crank except my arm is straight and the VE Anderson has a bend.

I am trying to find a replacement operator or gear. I have found a few operators that are a close match but no exact match. I am hoping you guys will be able to help or point me in the right direction. Andrew

Trying to identify this

No markings of any kind. I did notice the operator link arm seems to mount on the opposite side of the awning mechanism than the video I watched. Don't know if that helps. The house was built in 1972 in Florida.

I am looking for 4 left handed and 5 right handed cranks like the ones in the photo, the hole on the arm of is 3/8"

Need 2 rh and 2 lh cranks

Looking for help to replace the window crank and another part I might need. The windows do move freely.

I can get the window to open but I can not get it to close. The handle comes out of the operator.

I'm trying to find a replacement for this old awning window opener. the challenge is: the bottom two screw holes are not lined up (see photo) Do you know where I can find a part like this? Any other suggestions? Thanks.

I need help choosing the correct jalousie replacement handle. I've attached two photos. can you help?

We need a left hand window crank for windows placed in 1985.

There are no names or numbers anywhere on the windows. the straight bar hole to hole is 2 inches. top hole to middle hole is roughly 4.5 inches. Strait bar is threaded on the end for the screw. Please help. Whole housing is about 1 inches wide.

Left hand window cranks, no markings found. Need 3 presently.

Hi! I need a new crank for this window and I cannot find any labels or markings on the windows. House was built in the 80's. Looks like the space from top to bottom mounting holes are 5 1/8,the space between two bottom mounting holes is 1 1/2,and the arm holes are approx 2 1/2 to 2 5/8 apart.Any su ... (cont.)