Viewing all customer Discussions for:

39-114L Crank Handle, 11/32"

This is the original handle for our window. The number on it reads 40085 I'm not sure which handle will fit best for us.

Please help find the part number & prices for this 9" Crestline window! Thank you very much Wayne

Hello. I need to replace four Caradco operators, 9 1/2 in. long arm. Color is gold/light bronze. Please recommend replacement parts. Photo is attached. Thank you -

The attached photos are from a Marvin Casement window that was from +/- 23 years ago. I need two covers and cranks in bronze.

Replace the whole assembly. Pictured is a working crank.

Right hand casement window operatorThis is a small casement in a bay window right hand hinged from the outside

Looking to see if you guys have this part, it goes on the left window. I am going crazy looking for this part, nobody seems to have it.

Hi, Northern CT here. Believe I need to just replace the cranks. Can you advise on the right crank part number, using the pictures attached?Thanks!Eric

truth guard on on it I need the whole thing or just operator

Operator part numbers: -40055 -4 -T -LH

Hi We have three windows that the windows do now open. I have taken a picture of the part. The bottom

I have 2 casement windows with cranks that won't close all the way - 1 is right handed and 1 is left handed. I think the gears are stripped. The long arm measures approximately 13 inches. Do you have replacement parts - I think I need complete package - crank, cover and screws as well as arms. ... (cont.)

I need help confirming the correct window crank (left and right) for a 9 1/2 & 3 3/4 dual arm as well as crank handle and Caradco cover with appropriate colors. Do the colors fade over time i.e. would it make more sense to replace them all? Thanks!

My condo is about 30 years old. I need to replace this hardware. I cannot open some of my windows. Hope you can help me. Thanks

Single arm window crank with a #5 stamped on bottom of crank. 9 1/2" from end of arm to center of crank assembly. Stamped Truth, 10 years old, stamped 40050A on bottom of arm. Can you tell me model, order number?

I need to replace a truth operator comprised of the following part numbers: casting body 459002 that is 5" wide scissors arms 40510, 40511, 30895 (2) with total closed width =21.5" Which of your models do you recommend to replace this unit? I will also need a new crank to go with it. I would appreci ... (cont.)

Hello, We need help deciding on which parts to get to replace the the entire crank mechanism (hinge arms, track, operator) on our 1980's Hurd double casement windows (left and right). Could someone help with this? Double casement widow width each 17.5" Hurd windows House built in 1982-4 Thank yo ... (cont.)

Part number 30842R

20755 on short arm. Entry Gard TRUTH on long arm.

I need a new cranket for window as when cranked out its fine but when going back in rotating gear attached to handle backs out instead of cranking window in...on crankset its labeled aas truth entry guard with part number 40254