Viewing all customer Discussions for:

39-114L Crank Handle, 11/32"

I'm looking for repair parts for these windows. Can you supply them?

I am a General Contractor trying to identify these awning operators. They belong to Milgard fiberglass windows, about 12 years old. They are on a condo project on the island of Kauai. On 75 condo units, each unit needs 4 to 6 operators at this time. They have stainless arms with a white interior ... (cont.)

I need help finding a replacement for this window crank... the worm gear is stripped... thank you

I need one crank handle and one tie bar guide 558120

Hi, I was wondering if you all have a replacement for the attached photos, or if I can use different parts in place of these? The attached pictures are of the awning window operator and sash lock. The house that these parts are from was built in 1967 and I believe the window and hardware are Anderse ... (cont.)

Can you find this window lever for me? Please??? Thanks so much!

The single arm on 'this operator is 9.5 inches long. I need to replace at least four of them. As you can see the crank handle is located in the middle of the plate.

Hello, I would like to replace this crank window handle with a folding crank handle. Thanks, Nate

Need to price these out for a client Need hardware cranks and crank handles in dark brown

We currently have a Wright casement operator that we are looking to replace. On the arm it has the following number 07907. On the bottom of the casement operator there appears to be a number # 7107. I think. You can see by the photo that the number is partially missing because of the hole. ... (cont.)

Could you tell me what replacement part this might be in your inventory AND what crank handles would property fit this mechanism?Also, do you have any videos or info on how to best replace these without totally destrying a window casement?I think this is the correct mechanism, but not sure about the ... (cont.)

Hi - I have several windows in my house (built by Pardee, San Diego area, 1991) that need the crank operators replaced. There are no identifying marks on the hardware that I can find. I popped the plastic cover off and took photos of the interior. Any ideas?I found "EntryGard" TRUTH on one of the ar ... (cont.)

Hello, Jeld-wen customer service referred me to you. I have custom windows made by them and the window handles have began to break. They told me these windows are a discontinued line, and so I would need to find replacement through you. Do you have these? I would need 10 total, for left-handed and 6 ... (cont.)

Hi. I need to replace this crank handle because the inner rotating part seems stripped as it does not pull the window closed anymore. Can you tell me the replacement part id or number I should order? Regards.

Window handle not working. Can be forced to push the window out, but can't retract the window and the window doesn't sit firm. (Winds will cause window to rattle and bang.) Handle arm says "U.S. PAT 4083264" + "CAN PAT 1979 45012" Picture 8605: The adjacent window that works fine. Picture 8606 ... (cont.)

I need to replace these broken cranks. It appears that only the housing is broken. They will crank the windows open. But not closed unless someone is outside assisting with a little pressure. the handle/crank comes out of the broken housing when cranking them closed. They are American Craftsman mode ... (cont.)

I believe this is a plygem window that's missing a window crank. Can you help me?

Original long arm is 6" from end to end Both arms are stepped down

Trying to replace these two truth operators, can you help?

I need to replace the window cranks. I am not sure what would work.