Viewing all customer Discussions for:

39-114L Crank Handle, 11/32"

I have a two-pane window above my kitchen sink that has a crank mechanism on each window. I would like to replace the two crank mechanisms. I uploaded some pictures.

Crank/gear window handle

Hi, I have a broken crank mechanism and not sure what I need. I have attached a photo. Please let me know. Thanks.

Hello, I need some help identifying this window crank. The arms are ~12" long. The handle assembly has some stripped parts in it that are preventing it from opening and closing properly.

long arm is 9"

There is a main "Entry Gard" arm. But there is a smaller arm at the top of casement window and at the bottom. The top is fine. The problem is that the home sat for 5 years and the bottom small arm rusted off. #6799 in the pictures. Its a 6" piece that connects to a screwed in piece on the botto ... (cont.)

I measured #20810 at 4 7/16 main arm 9 3/8 large numbers on part R30842. I could reuse the old crank and cover

Identifying #R30842 on arm close to crank #20810 on small arm

Need replacing them. Windows will open but not close.

Hi, I need to replace the left and right side, could you please tell me what do I need to order. Thank you

Need to replace the crank mechanism, thr part the whole part the handle connects to.

I have one that is broken. The photos are of the working window hardware.

From what I've found I have FERCO brand windows, the arm that attaches to the window frame is 71/2" and the sliding arm is 7". I also need the opening mechanism as the housing is cracked.

I've a Hurd awning window. The glass in it is 17 x 17 inches. The crank handle is stripped inside the operator. The hole the crank operator goes into is 4 3/4 inches wide and the operator itself is 5 inches wide on the outside. When the window is open full way, the crank arms are about 11 inches lon ... (cont.)

Hi, I have two roto operators that have failed. Both are marked EntryGard Truth. Both have smaller arm length of 4.5 inch and longer arm length of 9.5 inch:Right roto operator has 20810Left roto operator has 31538If you could let me know what parts to order, I would appreciate it. I also need a new ... (cont.)

I have a double casement window with two operators. one side opens right and the other side opens left. Both old operators are bad and I need replacements for both.

These pics are from the right window, the left is broken can't open it right now. the parts is Entrygard true #31229

Please determine if you have a suitable replacement for this awning control. I have several other similar windows with broken handles, but this one is most critical. Please let me know if you have a replacement and I will complete the order. Thank you.

Hi, I need help identifying and ordering this part. It is for a casement window. Thank you

Vetter window. Can't close or open using the operator but can when I took out the screws holding the operator in place. The other side is about to go also