Viewing all customer Discussions for:

39-216 Single Arm Window Crank

40530 on bottom of arm. Worm gear striped, doesn

I need an entire operator assembly like the one pictured. The bottom side of the truth arm is stamped 41255.

Does this crank for casement window works as replacement for TheramalGard casement windows. Of

45108 on operator body 40574 on single arm Need one left hand and one right hand. Arm is 8 1/2 inches from pivot to pivot Mounting screws arem4 inches apart

It is a Truth brand, and the # I believe identifies it is 30744 although the following #'s were also on there, 40574 and 45108. The long arm is 9.5" in length. The crank to open'close is in the middle. Do you have a replacement for this? Sincerely, Sheila

Operator 1 opens a window that is approx. 32" x 55". The window opens on the right hand side; the operator and hinge are on the left. Operator 2 opens a window that is approx. 14" x 55". The window opens on left; the operator and hinge are on the right. I marked the paper in the photo with all t ... (cont.)

Hi Looking for a replacement crank assembly - stamped with model #30830 - 1990 the windows were installed. Do you have something that would work for my setup? Thanks, Randy

I need two new cranks. One for the window shown in the photo and another for the opposite window that opens up the other way. This is a Milgard window from '97. Thank you

I need truth window crank open to. Left single arm 9 in long from hinge to hinge please see picture of existing

Can't find any markings to ID the window or the operator/crank. Both left and right cranks seem to be stripped. Right crank can screw right out of the operator mech. Any help is greatly appreciated.

Looking for left window crank.

Hello, I need to replace a Truth single arm crank from a 13 year-old Marvin casement window. It looks like the 39-216 is what I need. Will the 39-107FK work with that crank? Also, can you tell me the dimensions of the 39-107FK cover? I need to make sure I can cover the 7/8" x 5" opening in my c ... (cont.)

The spiral mechanism that connects with the gears that move and open the window is broken off on the end and will not close the window. It says 'Truth Entry Guard' but the piece that connects to the gear is angled and the replacement part #39-036 is not angled. The measurements are also different. ... (cont.)

Hello: My operator seems identical to the 39-035 except it doesn't have a hinged arm. My arm is about 8" long tip to pivot point on the gear. Questions: 1. Do you have a 39-035 operator with a straight arm? If yes, price and delivery? 2. The gear seems to cover the mounting screw hole howeve ... (cont.)

Shown in the pictures is a left arm, I actually need the right. Not sure of the brand. The arm is approximately 9" long. Any help would be appreciated.

Just wanted to thank you for the quick shipment, etc! The arm fit and worked perfectly. This was quite a bit easier than I thought it was going to be when my original arm broke a few days ago. Thanks again!

I need to replace my operator. It looks just like the 39-216 unit on your website. The number under the arm is 40574. Are they the same?

Hi, I'm looking for replacement crank operator mechanisms for several BiltBest windows. Items 39-216 and 39-217 look similar. How can I verify that they are the correct replacement parts? Thanks & Regards, -Bill