Viewing all customer Discussions for:

39-216 Single Arm Window Crank

Please give me a call to discuss these operators.Thank you.Terry

i measured 9 1/2" crank arm and 5" casing on interior

I need to replace several truth window operators ( I measure the single arm at 8.5" from the center of the pin to the gear center pin)I also need several of the window limiters in the picture. (measure the limiter bar at 6" long)I also need operator handles and covers.Can I get part information and ... (cont.)

Hi I have 2 , 15" crank out windows that open but the crank out assembly will not close either window the 9"crank out you sell looks different to me , the house was built in 1993 , thank you David

which is left or right? window lock is on the right when looking at it from inside. 39-216 or 39-217?

Hello fellow Jerseyans, Hope you are all well. I have a 4 panel windows and need to replace 2 left and 2 right cranks. I want to make sure I get the correct parts. Where can I find the correct part number for each, as I was just looking at the picture and I noticed the 45108, now is that a part numb ... (cont.)

window is 20x50". bow window has 4 separate window panes with the outside 2 windows that open and lock. I do not see any markings on these parts. I think I need to replace the crank arm and crank. The arm is 11 inches and I can not take a picture as the window will not open since it is broken. ... (cont.)

I have a crestline window with a truth operator I am in need of both the left and right hand sides "picture shown is the right side

The single arm on 'this operator is 9.5 inches long. I need to replace at least four of them. As you can see the crank handle is located in the middle of the plate.

9" off set single arm 1/2 drop

The handle says "k k". The 9". Arm says "truth".

This is for an older Anderson wood casement window operator. the arm is 9 1/2 inches long. the number on the base is 45047. The number on the arm is 40530. The gears are worn on this on and will no longer crank correctly...Thank you

I have Crestline 4-panel window that are 20+ years old. The two outside panels screw open while the inside panels are fixed. One of the panels is rotted. 2 of the handles have stripped (or so I believe) and will not turn to open. The panels are 54 X 12. Can you help me? Thanks.

The first 3 pictures are of what I call the left had window, the last 2 pictures are of what I call the right hand window. I need the new cranks for both windows. The numbers on the left hand plate are-45108, on the other side of the plate the # is 4. The # on the left arm is 40575. The #'s on the r ... (cont.)

It looks like the 39-216/7 would work for me. I need the left and right arms. The stamp on the plate says 45108 and the underside of the arm has 40575. Under the arm at the connection point to the plate the number starts out 313 and I can't see the rest. The dimension from the center to the end ... (cont.)

This is the type like Entrygard. Left hinge looking from exterior. Sorry no photos.

The gear box broke Looking for a part see attached photo thank you

Looking for a replacement

I am good to assume that this is the Truth EntryGard single arm? 39-216 and 39-218? Can I also replace the cover? I'm looking to move to white for the cover and handle.

crank stopped bringing window in. It is a Truth crank. 8 and 1/2" arm. part #40626 stamped on the arm