Viewing all customer Discussions for:

39-217 Single Arm Window Crank

I have a customer that has several CRESTLINE casement window crank units that are stripped and not functioning properly. Do you carry Crestline or one that is compatible. Thanks, Dale

Description: Truth in hardware stamp. Casement crank. Need entire mechanism with handle.

I have one that I purchased from you guys that's too big and I need this one instead, is this 39-035?

Hello, I'm looking for this Truth casement operator and sash mount bracket and bronze handle and cover. It has a single arm with 2 step downs in it. I believe it may be 176- Entrygard Dyad. ? Thanks Tom Janik 2156518305 Also I am going to send some pics of door hardware I need at the same residence ... (cont.)

Looking for this TRUTH casement operator

See identifying numbers in photos attached

Hello, Looking to replace the operator for my casement window because the mechanism opens the window but does not close the window when cranked the other way. Casement window that is around the 1990s. Can you let me know what model this is?

Need replacement operator, guide, set of 10" concealed hinges for casement window measuring 34W x 46HMark

4840075 patent

Crank arm bent in hurricane need replacement

Marvin Casemaster French window vintage mid 90s

Above window in kitchen, special built size, both operators have stopped cranking open or close the windows. Took apart the operators and both seem to still mesh the worm gear to the crank gears but just turn and will not engage totally enough to open or close window. Just seems to have too much s ... (cont.)

I have two different Vetter window cranks from 1994. There are two photos of Window1, and three photos of Window2 Dimensions are marked in the photos. I realize I will have to remove that trim, but didn't want to do it today until I get an idea of when I could get replacements.

i measured 9 1/2" crank arm and 5" casing on interior

I need to replace both of these window operators as in pictures posted. They both have the word "Truth" engraved on the parts. Both operators are for left side crank windows. The long arm on both measures 9-1/2" in length. I am looking to purchase one of each. I do not need any additional parts as i ... (cont.)

I need to replace several truth window operators ( I measure the single arm at 8.5" from the center of the pin to the gear center pin)I also need several of the window limiters in the picture. (measure the limiter bar at 6" long)I also need operator handles and covers.Can I get part information and ... (cont.)

Hi I have 2 , 15" crank out windows that open but the crank out assembly will not close either window the 9"crank out you sell looks different to me , the house was built in 1993 , thank you David

which is left or right? window lock is on the right when looking at it from inside. 39-216 or 39-217?

Hello fellow Jerseyans, Hope you are all well. I have a 4 panel windows and need to replace 2 left and 2 right cranks. I want to make sure I get the correct parts. Where can I find the correct part number for each, as I was just looking at the picture and I noticed the 45108, now is that a part numb ... (cont.)

Have a Vetter window (installed 1992) with Truth operator hardware. The cylinder shaped piece standing upright in picture below is not functioning as the lower end has fractured/stripped grooved ring. The window cranks out OK, but with the lower grooved ring being cracked, the window is not able to ... (cont.)