Viewing all customer Discussions for:

39-512 SS 13-7/8" Awning Operator Track, Truth

Need replacement...crank gear is stripped. Thank you.

I am looking to replace this single arm operator with square attachment. Length of the arm is 9-1/8"

Can you plese find this part

I need this black clip for my casement window, but the combination doesn't seem to match the combinations of operators and shoes on your website. What do you recommend? This is a Truth operator. The arm looks like it's 13 inches long.

Trued to buy on the website but don show if left or right but I need one of each side. And two tracks.

Hi I have a window in the bedroom as shows in attached picture. The operator crank failed to close. I removed the operator but as it shows in the picture the end parts broken.How should I replace a new operator if I find one? how should I remove the remaining end parts from bottom of window?Do you h ... (cont.)

Hello, This appears to be the correct operator that I am looking for. However, the only operator track I see is 13 7/8" long. The track I have is 27 3/4". Is it possible that two of the 13 7/8" would have been used in my application? I didn't pay attention to see if this was the case when I ins ... (cont.)

This building has a total of 51 commercial casement windows of which approx. a half dozen units have broken window operands, either left- or right-handed (t.b.d.). We are attempting to locate a source and approximate pricing to bring replacements to Kansas City, Mo. If you have a compatible item i ... (cont.)

Crank has number 250-32 You have to push the window out about 8 inches for the crank to engage We have 5 windows

Anderson part #0531108

Purchase two (2).

Swisco, At the request of Tim Connelly I am forwarding the following for identification and replacement help. Windows are Anderson and not Pella as originally guessed. (I'm an Idiot) Right window is not functioning (crank just spins) and left window is stripped but opens with gentle assistance. St ... (cont.)

I am trying to find replacement parts for this hardware. The operator arm says GETTY Phila.(delphia) PA paten pendingEven if someone knows how to remove the operator arm from the operator. I tried using the two holes in the top to "thread" off the "cap" but was unsuccessful. I made a tool to do so b ... (cont.)

hi, I am looking to replace the hardware on a bay window. the original Andersen parts are way too expensive (the window is from the 1970's, at best). This is the hardware that I need to replace: Andersen #7073A Operator (Left Hand) with 7-1/2" Arm Length in Bronze Color Andersen #7073A Operator (Rig ... (cont.)

Need to replace

It was great that you could provide the Ellipse single arm operator parts 39-028E and 39-0227E I ordered one of each to try and they are good for my windows. However the round when at end of arm does not fit into existing track, too thick. I looked for track and thought I found it, item# 39-512. ... (cont.)

HI, IN the window operator shown in the picture attached, the bushing is worn out so I think I will have to replace the window operator because that bushing will be too hard to locate. I measured the full distance across the retractable arms for the operator with the window closed and it is 24". Do ... (cont.)

Casement Window Crank & Bottom Track Identification Request. Would appreciation any assistance that you could provide.

I need a replacement 'window operator', and possibly the 'channel guide' that the arm connects to.

is there a conversion number and unit that matches our andersen window cranks? we need 2 R's and 2 L's. Thank you. Peter