Viewing all customer Discussions for:

40-049 Complete Mortise Lockset, Brass

Does this mortise lockset come in a satin nickel finish? I'm trying to match other door hardware. Thanks.

HI will the 40-049 replace the papaiz lock it looks the same except the papaiz has a key for the out side and in side the lock i have is about 15 to 20 years old what is the differance between the 40-049 and the 40-089

Can you let me know if your Mortise Lockset 40-049 is a replacement for the Emtek 322 lockset?

Installation of new 40-049 lockset went well until I was installing the inside handle (last step!!). Handle would not fit into the rod in the outside handle - the rod "caught" on the casing of the set screw. Either the groove in the rod was not long enough or the casing for the set screw was embedd ... (cont.)

The latch is more slanted than curved, whereas the door can lock without having to turn the handle.

I need to replace a handle on a strom door with lock.

What is the mortise width?

Please describe the 6 9/16" installation hole centers for the 40-049. I have an Emtek door latch from a Pella storm door that looks identical to the one shown. However, I can not find any holes that are 6 9/16" apart.

With regard to the inside handle of the 40-049, what is the total depth from the faceplate the flat edge of the handle?

The width of the interior plate of the 40-049 replacement lockset is 7/8", note that the exterior plate is the same width. Take a look at the following picture that shows the interior plate with the width dimension.