Viewing all customer Discussions for:

40-058 Lever Handle With Deadbolt Set

The white door is a 4 seasons porch door, 1 3/4" thick, the holes are 3" on center spaced, standard backset. The Pella is old and latch broken, I saw you give the mortice to another post, but because of worn handles and trim, I need a complete handset. Thanks.

We need to replace the handle on our storm door or is there a spring inside that is defective we can replace? The handle is about 17 years old. PLEASE ADVISE! We think it's spring in the handle. Thanks, Kelly

I'm having difficulty finding a 4" bore hole replacement handle for my old storm door. This storm/screen door was put in some 20 years ago when we built the house. (I think we purchased from Sears at the time). Do you have a replacement handle for my door? Thanks for your help! Jo ... (cont.)

I am looking for the replacement handle in the gold color shown. The spring is broken inside the handle and the door will not shut properly. Thank you.

Hello, I can't figure out who makes this set and would like to replace it. Unfortunately the previous owner of the home passed away and there are no markings to identify the maker. I think it's a Larson? Any input would be great, thank you! Todd

We are looking to replace three locking door latches for our Sears Best Storm Doors. 1&3/4" holes for door latch (width) 1&5/8" door width (thickness) Hope you can help Thank you

No mfg id May have been polished brass at one time

The screws in the handle are 2 inches apart. No markings. The finish has seen better days, but the main issue is that a spring coils around the inside of the handle and it has lost its elasticity and doesn't hold the handle up any more. Is there an easy replacement for it, or do I need to re-drill ... (cont.)

I have a product that was made by you I need a handle replacement here is the model es337709. This is not a handle with a lock in it, it's just a open/close it's got a lever unit white in color for the back where it goes up n down like a normal screen door.

We have a cole Sewell estate series model 5500 door Am looking outside/inside lever

I have an older storm door with Cmech 1 knob type set (not a mortise set; see attached photos). Interior latch tension spring has broken and latch no longer stays closed. 6 Holes in door. Two main shafts are 3 1/2 inches apart and screw mounting holes are 1 3/4 inches apart.Hoping to find a set tha ... (cont.)

I need a door handle for a cole Sewell storm door Reg # 092700870. Brass finish? No deadbolt on it. ThanksChris

I have the screws but they don't seem to fit. They only screw in approximately 1 turn so all the screws are either too long or too short. I'm not if they are supposed to screw in further or not but I am not able to use this. The door handle installed easily. Not sure if I need a new lock or the ... (cont.)

Replace the old door handle

Can.2062353-5 is number on black inside handle

I have searched everywhere I can think and have bought several door handles for this door, but I cannot find the correct fit. Can you help? This is an old door which has been on the house for years! Thank you. K.~

Please indicate if you can supply the exact parts as shown, brass on the exterior and white on the interior of the door. Please reply with any questions.

Please see below. Looking for an alternate to replace (Cole Sewell). If you need any dimensions, I will get them. Please advise. Very truly yours,

I am looking for a replacement handle for the pictures I posted. I have included a number for the door too.

I need this whole assembly for the older model of Anderson/ Emco Forever Storm Door. It's been discontinued but old part number was 306999. Thank you for any help you can offer. I am a senior living alone and feel secure with this dooreven if it's old.