Viewing all customer Discussions for:

26-477 Top Tilt Latch Pair, 1-3/8"

I need to replace the window latches on my windows. I think they are HR windows, but can't be sure. I called them because the mfg # on the tag referred me to them, but they couldn't say it was there window because there wasn't another sticker to verify.

Latch measures 2 1/2" in length 7/8" width the center cut out slot where the slide button is measure 3/4"x 1/8"

Older windows. Do not know the make or model. Did not see anything inside the window, on the window or on the part. Windows will not lock. The piece that should come out (the tongue) to lock the window is broken.

here are some pictures of the tilt latch and the aama identification this is the only identification on the windows will need about 20 or 30 pieces, I am assuming there is a left and right.... but ill let you decide..

I need to replace several of these plastic pieces that allow the window to slide it open outward. Lowes and Home Depot have different kinds. Included the window label. Thanks, Dan

Looking for replacement latches/locks for windows that can be folded down inside to clean the outside window while inside. information from sticker on window Series: 375/380 AAMA/NWWDA 101/ I.S. 2-97 H-R40-48x72 MFR Code: HRW-1. Any help would be appreciated. Thank You!

In need of replacement window tilt latch - Measurements - Overall length - 2 1/2" Width - 7/8" Thickness - 3/8" Holes center to center - 1 3/8" Left edge to center of left hole - 15/16" Left edge to right hole - 1 5/16" numbers on the underside. There is a 4 above 022. Please let me kno ... (cont.)

Looking for some replacements. There is a symbol with the state of Texas and the initials MDC with a 1 under it.

Looking for a tilt latch for windows that are 20 years old but in good condition. Latch is 2 1/2" x 7/8" x 5/16", with hole centers at 1 3/8" and with one hole right at the end away from the window frame.

Hello, I am looking for some tilt sash window latches that will work for an Atrium Window series # 8500. I called Atrium and they told me these were discontinued but you guys may be able to help. Anyone know of any latches that will work? Thank you

I'm searching for a Danvid tilt window latch. Attached is the picture of latch on the window. width - 15/16 inch length - 2 1/2 inches screws - end of screw to end of other screw - 1 1/2 inches 1st screw is 1 inch from end of latch edge Kaye Thank you for your help.