Viewing all customer Discussions for:

58-002 Pile Weatherstripping, 3/16" x 3/16"

Hi, Enclosed pictures show the two sizes I need for my Crossley windows. The biggest is 5mm pile and 5mm width. The smaller one is 3mm pile and 4mm width. I don't know if you have these sizes. I'd only ned a small sample like an inch or two to see if it will fit in the slots of my windows. I will l ... (cont.)

Do you carry this seal strip? Plastic backing of this fuzzy strip is 3/16" wide that fits into a Tee slot channel along perimeter of exterior side of the sash. May come in extended lengths or roll that is cut to fit.

Pile appears to be 3/8" but is worn. Base width is 3/16".

Hello, can you please help me I need to get weatherstrip pile with clean fin My window is .187 inches base and height is I am thinking ether .187 or .200 Please help

Hello there, I'm trying to identify which Pile Weatherstripping I need for my sliding door, I attached a picture with the numbers the door has in the glass also the Pile Weatherstripping measurements. I'll be more the happy if you can help me with this issue. Antonio

Help identify weather stripping.Base 3/16" Pile 1/8" There is a thin rubber strip as well.

Approx 3/8 base with 3/8 inch high

Picture is quite worn out felt, actual height is .180-.200" Measured with caliper: Channel is .187" , Weather Strip Base is .170", and Felt is .180-200" High Original Windows are by PGT Hurricane Windows Cant seem to find any material where the base is smaller than 3/16 or .187"

Just wondering if you could help me identify this seal .it is not glued in just slides in a grove on the sliding door if you could help that would be fantastic thanks andy

It looks like you offer the window seal in grey but I do not see it in white.

All the windows in my home are from the same manufacturer. The one that looks like a brush fits into a 3/16 slot. The other one also fits into a 3/16 slot, but it has a short nap brush with a plastic strip down the center.

#58-002 what is the number to it if it is 5/16 wide and the pile is 3/16 can't seen to find it

I need 4 of these. You can call me thank you Jim

Need new brush strip for vinyl patio door and frame. What do I need and how do I install?

I have 8 large windows with each sash weighing 20 pounds.I also have 2 smaller windows with each sash weighing 13 pounds. The rod length for all the sashes is 29 inches, with a rod diameter of 3/8 inches. I believe that the "Red Tip" balance will satisfy my needs for both window sizes, but I'll need ... (cont.)

Looking to replace this material in my sliding glass door

Looking to buy tilt latches, balance assembly, locks, and weather stripping for Simonton window. Picture contained window sticker. Thank you!

Hi! Taking my old pile weather stripping out, it's base appears to measure 1/8" but it looks like the smallest base size you offer is 3/16". Not sure on age of existing WS so maybe age deterioration could account for 1/16"..? Could the 3/16" base size still be an option for me? Are there 1/8" base ... (cont.)

I am looking to replace this felt seal for 36 doors.