Viewing all customer Discussions for:

58-050 Gray Pile Weatherstrip, 7/16" x 7/16"

Store front door single strip up front edge, single strip up back edge removable metal trim on door between. Aprox .5" gap between doors. Aprox 3/8" back of strip

I'm purchasing complete channel balance (with top& bottom), The channel without attached parts is 28", stamp option is 27 C. Also I need top sash guide. I have submitted some pictures. Please let me know the parts number . Thanks Mohammad

Appears to have originally been held on by a self-adhesive strip.

I am looking for a pile weatherstripping with a full 1/2" backing and 3/8"-7/16" pile height. We have tried 7/16" backing, but it will not lock in the groove and falls out.Pat

Just need help with what I need to purchase to replace this for my customer

This is off tube lite door here a few ics

Hello, I work for a school in Barberton, Ohio. We are trying to find replacement for our door weatherstripping. I came across your site on Google and think I may have found a match. Can you help out in anyway? Thank you!

The weather strip is from the side of an Aluminum Awning Window. The red arrow in the attach window jpg shows it's location. I can not find any names or numbers on the windows. Thank You Tom

We have two swing metal doors that the felt has become very flat and worn out. I was wondering if you can help me with a recommendation?

I'm attaching pictures of the old and new weather stripping. Also of the door to show the gap between the paradoors, almost a 1/2". I tried the Swisco 58-161 but that doesn't cut it, as seen in the photos. New stuff is on the left, older on the right. The 11/32 track seems to match but I think a hei ... (cont.)

I have a Hurd skidding door. Looking for two bottom weather stopping part number 166136. Any help? Kind regards.

As you can see my weather stripping is very worn. The base is 1/2" wide, and the pile needs to be 3/8" or thicker. It is a wool pile style weather stripping.

Please see the attachment of what I am looking for. Again, the backing of this commercial door weather strip is about ½inch. I look forward in speaking with you .

I am looking for replacement stripping for double entry doors. The metal strips that hold the stripping is approximately 1/4" x 9/16". Each door is 83 1/4" x 38". There is also a strip along each mortised latch set that needs to be replaced. Both the metal strips and the insulation stripping its ... (cont.)

I cant seem to find them thou Any suggestions

Do you have a part that is like the 58-050 but would have the dimensions of 7/16 wide but only 1/4 or 5/16 thick? The double doors we have are close to 40 years old.

Can you help me replace this wool pile it is 3/8" wide by 5/8" tall

I was wondering if you could recommend a replacement part for a 1940

I need some replacement astragal material as shown in picture. Thanks, Troy

Hi, Do you have anything in your inventory which best matches the t-slot profiles in the attached pdf and pictures? These are gaskets used on a 1960's wildcat travel trailer. Let me know if you can help. Thanks! Alan