Viewing all customer Discussions for:

58-053 25ft Kerf Mount Bubble Seal, 5/16"

This weatherstripping slides into an aluminum track used as door weatherstripping

This is the bottom seal on my aluminum widows (see photos). The windows were installed when the home was built in 2001. appears to be a 1/4 bulb and approx 1/8 inch (3mm) kerf. looking for replacement seals.

Hi, the windows are Trimline DR-200 from 2012. When painting the sashes, paint bled onto the weatherstripping causing it to become brittle and matted. I hope you can see that the base is "V" shaped. The measurements are 1/8 inch wide. Thanks for looking into this for me. Phil

Hi, we are looking for the rubber or vinyl seal shown in these pictures. Do you have this part? Window slot is about 3/32", bulb is 1/4" OD, looks like barbed? but real worn out, maybe kerf?, for old aluminum tilt balance windows. The tilt balances and latches (26-295) I purchased on previous orde ... (cont.)

Sections of these came off my Bella sliding doors. They were installed about 15 years ago.

I am looking for replacement bottom door seals as noted in the photos. One seal is a type of wiper seal on the bottom of the door and the other seal is a bulb seal (~1/2")bulb diameter. Third photo shows the door serial number Thanks. Mike

Attached picture shows piece of seal from existing window. Looking to replace this seal in a couple windows. Do you have a matching replacement?

The bottom strip on my door wall came out. Looking to replace it

Looking for help identifying the size of weather stripping this is for replacement.

This pile SNAPS into a channel on the casement window, it is NOT adhesive or slide in. Do you have a product that can work? Thanks

I have twelve casement windows that I'm replacing the insulated glass in. That part is going fine. I need help identifying the kerf type weather strips that are attached to the actual inner sash. And the strips that are in the top and bottom of the frame that the sash closes against. The windows are ... (cont.)

Trying to find this particular style kerf.

Contractor ordered wrong windows and I am remaking larger ones. These are double hung single pane windows. Going from a 20"x 24" tall sash to a 22"x 28" tall sash. I need similar balances and the weather stripping. Can you help me out? Thanks Carter

Hi, I am placing window seals in the Hurd Casement windows. Appears in the website that the old style seals have been replaced. Is that a good assumption? Can you help with the new style seals? Thanks

I need complete set for 2 windows

Hello, We have Pella insert windows that need the seal replaced. What product do we need. I believe we have 17 windows between 24 and 36 inches wide. Thank you,

These are the window seals on JELD WEN casement windows on a house constructed in the early 80's. There are 2 seals on each window, one on the sash and one on the frame. I need seals for 3 windows, each measuring approximately 64 1/4" high and 23" wide. I also need the window operators for 2 wind ... (cont.)

I'm looking to replace my window weatherstrips. I'm wondering for you have these window strips/seals. I've included the photo and a measuring stick next to it. Lower window pictures labeled 1 to 4 For the lower window strip. The strip was not attached to the lower window instead it was at the botto ... (cont.)

Here are the profiles I'm looking for....1000 ft. Of each ....im a home builder and we are responsible for supplying new weatherstripping for an existing home project

Windows are original construction pre 1995. I can not remove the weather stripping for identification WO removing the sash which does not appear to use tilt latches.I can not figure out how to get the sash to move either L or R. In order to remove it. Can u help? Thanks, g