Viewing all customer Discussions for:

58-053 25ft Kerf Mount Bubble Seal, 5/16"

Looking for this seal for Apollo low-H 94-4 windows

Need the replacement for this weatherstripping Looks to be foes inside but not solid. Did the measurements and they were 1/4" and 1/4" Thanks

I have Wenco windows[now owned by Jeld Wen]. The windows are about 25 years old. I am trying the replace the part in the window jam where the pivot post of the window is inserted. This part I believe is called a friction shoe. I am also trying to replace torn weatherstripping in the window. Please s ... (cont.)

I emailed earlier, but the attached files for the pics were too much.

Do you carry these grey inside edge white outside edge thanks

I have sent 3 photos. The first two show the only part left that is intact. The "flat" plastic section goes into a slot along the outside of the lower window frame near the bottom. Then the bubble tube folds under the window. You can see the slot in the third photo. The length of the whole piece is ... (cont.)

I need the window seals for Kolbe casement windows that crank out. I think it is 2/8", but it is torn and distorted.

I purchased the 5/16 kerf mount bubble seal and would like to know the slot size for installation Thanks

Looks like it's all one piece and can't find a replacement black bottom piece

Need Parts

I just placed an order with you (#1719602) for 25ft Kerf Mount Bubble Seal, 5/16" 58-053. It's the horizontal strip between the lower and upper windows. Can you confirm that this is a suitable product for this? Thanks.

See photos

Looking for Kerf Mount Sweep Seal for an old sliding door system. I can't determine the original manufacturer. See attached photos. Thank you!

Sorry for the blurry installed seal two photos. I think you can make it out how they installed. This a threshold seal between the fixed and sliding wood windows. The two rib seals are about 1/4" spacing, maybe 1/8th or 3/16th inch long.If not found, any similar substitute would be appreciated. Whit ... (cont.)

Good afternoon, I am looking for a piece of weather stripping for a Milgard Trinsic double French door. Please let me know if this is something you carry. Thank you, Phil

The seal between the exterior sash and main frame

Any idea what part I need? I have several windows that need this glazing gasket replaced. The flat part is 3/8" and it looks like it should press fit into the channel of the window frame. House was built in the Pacific NW in 1968 and has black aluminum frame windows - I have not been able to find ... (cont.)

I need to replace the weather stripping for four sets of double outswing doors, all of which are 8' in height. The larger weather stripping shown in the photos goes around the perimeter of the doors. The smaller weather stripping goes on the astragal of the doors

These are wenco windows from the 80s(?) Just replaced the jamb liners and all the vinyl parts between the upper and lower sashes are shot. We have a larger window with sheetmetal in the same spot but it looks possibly home made.

This seal runs along the top and left and right sides of the window frame. Do you have anything that will work to replace it. I have included a photo of the groove in the frame that receives the weatherstrip. Thank you for your help.Marc