Viewing all customer Discussions for:

58-158 Gray Pile Weatherseal, 7/32" x 5/16"

The measurements are 1/4 x 1/4 and seems to be vinyl with foam inside bubble. The flat part squeezes into track on window frame

For a older Larson storm door. No numbers found on door.

I am looking for a pile type of weatherstripping that is like the one in the photos and the attached drawing. I looked at your web site but was not successful in finding a two fin pile piece.

Good morning, Ive uploaded 3 photos. We need some weather stripping about 1/4 inch wide. I just need help identifying the proper one. Ty.

Hi, I need help finding a suitable replacement for my weatherstripping.

Hi, I need to replace some black pile in an aluminum, double door store front doors and I'm having a hard time finding the right match. The width of the pile is 1/4" but is extremely tight in the aluminum channel, although assuming new pile will go in easier. The height of the pile appears to be 5/1 ... (cont.)

This looks to be 3/16 by 5/16ths with a fabric band in the center of the bristles. Hopefully you have something suitable to replace it Thanks Jim

Hello, need help with getting some new felt for several Guardian sliding doors. I think it is 7/32 x 5/16 and it is gray pile. Please advise. Thanks

what size do I need? I'm looking for finned and no adhesive backing

Stamped ID on window: Caradco. Low E2 IGCE. CBA IGMAC. CIG-3 3-96

Hello, I am looking for commercial door weather strip. 0.6 cm

I'm looking for fin seal strips for a Cardinal (I think) sliding patio door. Bottom fin strip is 1/4" or 7mm wide, and the vertical fin is 1/4" tall. Door height is approximately 76-1/2" tall. I also would like to replace the top & bottom rubber seals on the stationary door (where the 2 doors meet ... (cont.)

Gray pile weatherstripping, base measures 3/16" wide and has a 1/4" pile height; It has a fin-seal in the center of the pile. Original weatherstripping in our twelve Millguard windows in our home (built in 1999).

Hi, I'm trying to find replacement pile weatherstripping for vinyl clad windows that are about 30 years old. The base looks to be about 7/32" and the pile 5/16". The base slides easily in the track, so it may have shrunk over time.The pile appears to be wool, but I am not sure about that. The pile i ... (cont.)

weather stripping for a Milgard vinyl horizontal slider window.The "base" is .25" wide and .02" thick. The vertical piece in the center is .17" high including the base.Don't know the height of the pile, it's worn. Probably .25".I need 75 feet.Can you help?Thanks Scott

I ordered 3/16 x 3/16 but it's loose. I think it's a 1/4 x 1/4. Can you help me identify correct size? Also my single hung window does not come out completely. I have pictures too.

I need help identifying and replacing the seals needed for my windows (they are ~21 years old vinyl single-hung). As you can see, I am getting condensation because they are not working anymore. I cannot find a way to remove them and I would need help figuring that out as well. I have tried to inc ... (cont.)

Thanks for the help. I hope you have our size..

Was able to find most of my parts easily, with 2 exceptions: 1. Plastic clips on the top of (left-right) slider windows 2. Wool pile weather-stripping, measures 3/16" (width) x 1/4" (pile) in gray 2a. product code 58-127 is the proper dimension, but wrong color 2b. pictured are two different ... (cont.)