Viewing all customer Discussions for:

70-009 5 Pack, Screen Plunger Pin Latches, 5/32"

Hello - I'm trying to determine which replacement pin I need for my window screen. Please see if you can find me your pin that would work on my screens. As you can see the measurements are:Width if frame material: 3/4"Distance from end of pin to bottom of cap looks like: 1.0"O.D. of plunger tip: 3/1 ... (cont.)

I am looking for the small white tabs to hold screens in

Do you carry these pins for screens? They are on the top of the screens. Not spring loaded but stationary. They are about 3/16 diameter and they stick out of the frame about 3/8.

Holds the screen in place at the top of the screen, latch pins are used to secure screen in the bottom.

No markings. Appear to be plastic. Used to fasten screen to sill. I wish to purchase replacement push pins.

We are replacing these pins do you carry them. I believe the length is 1 7/16. Not great with a tape measure so please tell me if this is correct.

they are plastic with a spring load to attach to window (Anderson screen)

Hello. Looking for these two Lania window parts. Dimensions are: a: 1 7/16" L x 3/8" D x 1/8" Thickb: Spring: 1/2"L x 3/16"R with 1/4"R x 5/16"R plastic cap with flangeThank you,Steve

I have never seen one of these before. Not sure what it's called. Came from a discontinued Anderson Window Screen. Are these available? It also wraps around the backside

Hi, having trouble locating pins to replace. Screen frame is 1 inch. Please advise if you have something comparable. Thank you.Nancy

Hello, I was wondering what the best replacement is for the spring loaded pins. The holes are 11/64th in diameter. Thanks.

Need plastic pins for window screens that hold screen in place

The old Marvin Window plunger and rabbit hole. Plunger needs to be less than 5/32" by a slight amount to fit the rabbit hole. Will part #70-009 compress a bit so it might work?

I am looking for the pins that screw in at the top of the screens and can't find them. I attached a picture of the pin I took off on one of the screens as an example of what I need.

Hi, I have an unknown brand skylight. No identification markings on the frame. The screen measures 23 2/8" by 19". There are two pins that hold the screen in place. The pins have corroded and I need replacements.

Hi...I need to replace some broken screen plunger assemblies. The total plunger length is 1 5/8" long. The diameter of the plunger that protrudes from the screen frame is 3/16 and approx 3/8"long. Appears that somehow a spring is contained I am unable to determine who made the window. ... (cont.)

Hello, I'm looking for the pins that are on the top of the window screen that help to hold the screen in place. They insert it into the top of the window. Thank you.

I have screen frames that are 1" X 5/16". Will the screen plunger pins 70-008 and 70-009 work on this width of screen frame?

how do I determine which size screen plunger pin is the correct replacement? 5/32 or 7/32 ?

Hello, Can you help me find replacement pins for Peachtree Window screens?