Viewing all customer Discussions for:

80-003 Securing Bracket

I have two brackets for my sliding patio door but I need more for the door to stay in its frame. The top of the door is not in frame. Its an older door and larger than what they make now.

Hello Do you guys have this type of bracket? thanks Lily

I'm looking for two door handle; 3 1/2 center to center hole 5" center to center hole and 2 door stopper.

Good morning, currently in need of some fixed door panels for my sliding glass door/ fixed panel combo. When we had to replace one of the sliding glass doors they lost several of clips. If you could just provide a part number or any assistance would be greatly appreciated.

Brace on right side. Holds no moving in place

This part just came off my patio door but I cannot determine where is it from. Is it broken? Does it need to be replaced? Do you have it? Otherwise, could you let me know where is it from? Thanks in advance for your help. Lucho P.S I am an old customer of Swisco

This keeps non-sliding door firmly closed.

Our door has no manufacturer info. It is a generic sliding glass vinyl patio door, 60" wide, with one door stationary and the other sliding, left hand slides when viewed from outside the home. We need help with a couple of parts. (1) At the top end face edge of the stationary door where it is besi ... (cont.)

Hi, I'm looking for parts to help fill the gap/stop the draft and outside world getting in on what I think is a set of acorn 2500. The third picture shows what I think is some draft stopper attached to the top of one window, but the others are missing it. Similarly on the bottom, any suggestions? ... (cont.)

Trying to locate a replacement for one of these cleats which anchor the stationary panel on a sliding glass door. No identification on the door at all. These are plastic, but metal would be even better.

Hi, the attached image is of a plastic part that is mounted at the top of a sliding glass door. It seems to both guide the doors as well as prevent the door from being lifted out of its tracks. Do you have this part, I looked for it but could not find it. I'm the homeowner, working on reconditioning ... (cont.)

Securing bracket for stationary glass panel on aluminum 3 panel patio door. Does not have to have rubber bumper since door slides opposite direction to where clip is missing. Material is aluminum.

Attached to the top and bottom of the stationary door is a small aluminum plate around 2 inches square with brushes on each side. There is an oval mounting slot where the plate is attached to the fixed frame. I need 8 of these for 4 doors. Some are missing and the others are worn out. ... (cont.)

This piece screws into the frame of a sliding glass door and secures the stationary side. It is dark tan (light-ish brown), but color not significant. Photo 4a shows it in place. Cannot find markings on the door or frame to identify a manufacturer. Thanks for any ideas!

The picture is horizontal but it should be vertical, This piece holds in the nonmoving side of the patio door. I need to know how to order and how much.Thank You,Dave

Does Part 80-003 come in white ? Do you carry similar shaped parts with slightly different dimension ? Thanks, Alan

Would you please help me identify the part in the attached image and let me know if you carry it.

Hi - I'm looking for something similar to the 80-003 for a ~1980 Acorn sliding door. Can you put a picture up showing all the measurements? It is to hold the fixed panel in place. You already have the "height" at 1.5". How about the width of that same side, the width of the perpendicular side, and t ... (cont.)

We cannot get the sliding Dorwal 1200 door out because of inside tile higher than the bottom slide bar; how does one remove the stable door so that we can then remove the sliding door towards the outside rather than the inside of the house. Thanks. (I recently bought several new rollers 81-030 for y ... (cont.)