Viewing all customer Discussions for:

81-004 Patio Door Roller, 1-1/2" Steel Ball Bearing

Astr bec omcoTrying to find replacement slider door wheels

This door was probably original to the 1972 house. I need to find replacement roller assemblies. I've attached photos.

marking are as shown Wheel dia looks to be1 1/4 Which rollers do I need Door is carado I belive

Unable to locate any identification markings on the door or parts.

81-004 doesn't seem to match. This roller is 1 3/16 tall, the screw hole on top is about 1 1/8 from wheel end to first edge of the screw hole and about 1 3/8 from the other end to that first edge of the hole. The length is about 2 11/16.the width is about 11/16. I'm not sure which measurements are n ... (cont.)

2rollers bottom of sliding doors approx. 3 inches wide

Need to find one asap please

I need, if you have it, a set of rollers for my glass sliding doir

Did not see any names or markings

Do you guys have this kind of roller for an aluminum door?

Hello, I have a Sunseeker boat which has a sliding door mounting 4 rollers made by P.E. Del Mar - P/N 3684, Model: AD1-323-LS (from their catalog). However, I am not able to find anyone who sells it and I was wondering if you could help either by pointing me out to where I can find them or if ... (cont.)

trying to find this roller. PPG Herculite K, Tempered Safety Glass, ANSIZ-97 1-1984 1/8 - U, SGCC-1110 4013786

I cannot find a door roller I need it has inch and half wheel quarter inch wide. The casing is 2 5/8? length and 1 5/16? from top to bottom and 1/2? wide.new discussion

I need 6 of these PE Delmar rollers Thanks for your help

Looking for a PE Del Mar single roller, not sure part number, to fix my sliding door. Jarmin

I have a gammill quilting machine that was bought in 1985. I need the rollers for it. Any help would be greatly appreciated. Wilma C

Can you look at my sliding patio door wheel and tell me if this is yours Please see attachment Please make sure the wheel fits over your stainless steel track repair that will be ordered with it. The track I will be putting the repair cover on is .1874 or 3/16" wide which will be the inside dime ... (cont.)

Photo #3 of only labeling found on the door I believe it pertains more to the glass

Letters on top of the roller: ASTR BEC OMCO. I didn't realize roller sizes would vary so didn't measure them while the assembly was out. The background of the images is 1/4" graph paper if that helps.

My part pictured is from a door of unknown brand. Says Production Enterprises on it. I think it's your #81-004, seems to match the measurements.