Viewing all customer Discussions for:

81-004 Patio Door Roller, 1-1/2" Steel Ball Bearing

Do you carry this roller? Or sell a roller that will be Universal for this replacement?

Hello Swisco, Can you help me find a replacement roller like this? Its for a sliding glass door, these were installed in the 1990s I believe. Here are some pictures (attached here). Any information you can provide will be most appreciated! THANKS!!

This is a pic of the rollers I need for my door. I need two. It's an older door with no markings, so I don't know the manufacturer. I've looked online for these type of rollers with no luck. Can you help me please? Thank you, Jamie

Hello, I am looking for some replacement rollers. I would prefer to have stainless if that is a option.

need 20 patio door single roller assemblies. p.e. del mar P/N 3727, Model A1-523-LS, steel housing, 1&1/2 in. steel wheel.

Looking for replacement assembly. Only one of the two rollers is bad - a ball bearing came out - but might as well replace both.

need door hardware

Stamped on one side A-S. 7837 Nyc Looking for 2 sets Thanks. Jack

I just placed order#800183 and suspect that I've ordered the wrong bottom rollers (81-004). My patio door is a 1984 Peachtree Citation 80. I will not remove the door until I receive the replacement parts. Is what I ordered correct, or is the correct bottom roller p/n 81-112? Can you verify and if in ... (cont.)

I have gone thru the PDF for all the door rollers, but have been unable to pin down which rollers I have. I need to replace all 2 rollers in 4 separate doors. The Mirrored Door Rollers I am looking for look like the attached photo, and I could not find any part number for them. They are nylon roll ... (cont.)

looks a lot like the 81-004 roller assembly.

In the past, I purchased roller sets (appx 1.5-inch by 3-inch) for a sliding glass door. I'm looking to re-order roller sets like the ones I obtained from Swisco about 4 years ago. The roller sets are for sliding glass doors. (There may only be one roller per set.) The sets are installed by fricti ... (cont.)

Hello, I need replacement glass door rollers. The axle broke on one. Please see attached picture. The ball bearing wheel is 1.5 inches. The housing is about 7/16 thick and 1 3/8 deep. The housing has the markings A-S 7873. I don't know the manufacturer. Many thanks, Ahmadali

It looks like 81-004 or 81-277 but i can,t remove it. It is in our sliding heavy door. John

In need of 2 sets of door rollers for the above model patio door. Please let me know if you have any of this door rollers. Thank you, David Wilkey

This is my roller assembly, I require 2-each. Also there is a felt pad in the bottom track I would like to replace.

1960's latch is broken on our DorWal slider door (images show broken latch separate from door; door handle still shifts perfectly up and down using turn knob). Is there a replacement latch available or alternatively is it possible to replace the entire handle set but still use the existing sliding g ... (cont.)

Hello, I need a pair of these for my sliding glass door. Can you identify them and if so do you have them? Thanks! Lynn ASTR BEC OMCO

Need order number for the roller pictured

This is out of a 31 year old slider made by Trimslide, who are out of business. Can you match this up for me? Thanks, Paul