Viewing all customer Discussions for:

81-018 Sliding Patio Glass Door Tandem Roller

I would appreciate your advise on the following Patio Sliding Door issues. The patio was rough to open and I pushed a little hard and the lock felt off. Questions :The door is not moving smooth. I tried to clean the bottom and not much dirt being removed. Is there something wrong with the rollers un ... (cont.)

Hello I'm trying to find replacement parts for door pull set and the wheels for the sliding door. Any help would be greatly appreciated -Sam V

1GMRC-96106 Calgary 2002 G.B.P Sol-R1G05. I believe this is a Gienow sliding glass door.

Will this roller glide fit a Martin sliding door??

We are looking for this wheel part and housing that goes below one of our apartment's balcony door. It's from about 1971. The windows are Pella, so we believe the balcony doors are, as well.

I'm wondering if Swisco has this or direct me to the where i can locate this roller. The wheel diameter has to be 1 1/2"

Hi,may I need please the sling doors rollers. I can not..what item foto is?? Measure is 1 1/4Can you please send a video how to install the door back.Thanks I appreciate your help.

From outside of bracket where the screws go its is 6.25 inches long. From highest point where wheels are the bracket is 1.25 inches deep. No other markings to be found.

one is truth 30410 the other, truth 31761. Original from 1995.

I have a 6' and 8 foot PGT slider with Hurricane Glass. I need 4 rollers (See attached picture) and one each 6' and 8' sliding door track cover. I also need 4 replacement plugs that I broke getting to the door adjustment screws. Please provide part numbers and pricing for each item. Lastly, on t ... (cont.)

Need wheel sets for a Hurd patio door model 1800

I have a 2008 Peachtree Citadel sliding door. Which of your various rollers is a best match for the present roller that came with the door, part #34521050? Thank you George

This door was here when I bought the house in 1996. Both roller assemblies are shot. The inside door lock lever says Andersen. There are no markings on the existing roller assemblies. Which Swisco part should I order ? Thanks.

My doors are 36 years old, doors are very heavy. Would 1that part be the 80-128 rollers?

Looking for 2 replacement rollers for the door as it's not sliding easily. Couldn't find anything with the additional brace on top like this on your site. It clearly stated Truth 31761A on it though. Any recommendations?

Guardian 8 foot door - rollers are shot. # on Door is: ANSI-z971-1984

It came out of a guardian sliding door and there's 2 of them a pair. I don't think the #'s off the glass will help but if u need them lmk? Thank you, Ronnie

Hello, I need a tandem roller for a California Classic sliding wood door. It's about 25 years old, and I'll probably need about 4 of them. It has a slotted screw on one side, and a Phillips on the other.Could you let me know if you carry them or not. Thanks Patrick

I have a 92" height aluminum patio door that's hard to open and close.Cleaned tracks and adjusted rollers but it did not make any difference. The only readable information on the placard is SGD-R20. Replacing the rollers is my next options and would like to know if you have the part number and avoid ... (cont.)

Greetings! I need 2 replacement rollers for a Hurd sliding door. The existing rollers are marked Truth 30410 made in USA Also, if it is possible, I need 2 other items for the same door: The felt channel that sits over the rollers. It is approximately 9/16 wide and "U" shaped Also, a bottom guid ... (cont.)