Viewing all customer Discussions for:

81-018 Sliding Patio Glass Door Tandem Roller

Hello there, I am trying to find a replacement part for the Truth 30410. Do you have this part? Thank you.

This picture was sent to us by a customer. I don't have access to the roller at this time. If you need more to identify it I'll try to get it to our shop. Thanks, Tom

I need replacement parts.

Tom, I have recently purchased a home. It has 2 8' sliders, identical. No markings on them that I can find other than the herculite stamps on the glass. I'm trying to adjust the rollers and it appears they have a hex/allen head key, but I have several sets of metric and standard and none ... (cont.)

Hi, the rollers in my Milgard sliding door are worn (dual wheel roller bearings) out and the door is difficult to open and close. I have have removed, cleaned and inspected them. Mounting holes are 5 3/4" Center to center. See pics... Any help you can provide is greatly appreciated! Brian ... (cont.)

I need help identifying or finding a replacement for this door roller

I need two replacement rollers for an exterior sliding patio door. The current roller is manufactured by Truth, with the following numbers/markings: 1980 U.S. PAT. 4,194,266; 1982 CAN. PAT. 1,126,579; and 31761A. Do you have a part that replaces this one?

Please identify

This assembly is broken, the bearings and wheel have given out. I would like to replace both of them but am having no luck in finding them. Any assistance would be greatly appreciated. This door is extremely heavy.

Need hello identifying part

On one of these two doors the hardware broke and the the little pin that pushes in on the latch when closing is gone so I removed the latch from jamb and have the door wedged shut. Need new hardware for both doors to replace these. Would like a dark bronze finish. Also, if you can identify these ... (cont.)

Hello. t appears I have made an error. My intent was to order a like-for-like replacement of two "Truth 31761" tandem rollers.However, the 81-018 that I received - while they do fit the mortise opening - are too shallow, and therefore, put the height adjusting screw below the door's access hole, a ... (cont.)

Please show me where I can find parts like this

Lettering from between the glass on the side: Hurd IGCC 276 CBA lettering on the upper corner of insde glass: 4861 8813309..other lettering unreadable doors installed in 1989

need a new roller for sliding door. Delmar Roller Corp. US patent 3996643. may be part number 3731 but not positive. Thanks

I need your tandem patio door rollers part no. 81-018 but i need 1 1/2 rollers.

Hi there, The roller is from a wood sliding patio door. See picture attached. There are 6 doors, we would need 12 rollers. Thank you!

No markings,brand on door nor hardware.

In need of replacing part from Delmar Engineering Long Beach, California. The track is 93 inches long in total. Need track cover and rollers to fit.

Do you have replacement rollers? Thanks. Gary