Viewing all customer Discussions for:

81-023 Sliding Door Roller, 1-1/4"dia. Steel Concave BB

This door was installed new when the hose was built 20 years ago. The pictures are taken on 1/4" graph paper(I think). Unfortunately I did not measure anything or put a ruler in the pics for size (uhg!)

Need help determine the replacement for this

..

Single roller, unsure of wheel diameter at this point. This is a heavy alum door and window

The diameter of the wheel is 1 1/8". Note: the photo of the part outside of the door is very bent from removal. there is a hole for a screw on top of the part (see in photos) that holds the glider in place. If helpful, the manufacturer of the door was patio enclosures, inc.

Need 6-8 replacements to match as close as the photos

Can you identify this part number for me?

Need two plus 80-102 & 75-077

We have an "ANSI AAMA 101-85 SGD-R20, Series M-800/M825/M850 door". We are needing replacement rollers for the glass sliding door, bottom.

I need to replace two rollers. The rollers have a specific fit to slide into the aluminum framing. I have one roller that works and allows me to adjust the height, but the other screw on the other older is rusted frozen. It says PATIORAMA on the door handle, and was likely installed in the late 6 ... (cont.)

Looking for replacement rollers for glass door that are about 50+ years old, hopefully these photos will help to identify the parts we need, thanks for your help

3/4 inch wide x2 5/8 inch long. What do I need?

Need to figure out what the replacement part is for this

Dear sirs: I have an older sliding glass door (probably 30 years) It is vinyl covered aluminum door The rollers are not the standard wheels but use a series of rollers to move the door Had 2 sets. The back set is worn out and you have to lift the door to make it move Please let me know of any addit ... (cont.)

Need two concave replacement rollers for older glass sliding door. Pictures attached

Rollers 2 only on bottom of door. Held in place by screw from edge of door and one from above. Markings: Row 1 "A-S" Row 2 "MYC" Row 3 "7867" Thanks for help locating part. Zack

Looking at the Del Mar web site, I believe this unit is SKU#F3727. I'm pretty sure this is a 1 1/4" wheel. These are used in a pool environment, and the doors become very hard to open or freeze up after a few years. We need 10 of these units. Would stainless steel or nylon wheels prevent this? ... (cont.)

Searching for replacement part for this sliding glass door this is approximately 50+ years old. Looking for complete roller kit or the tool used to extend or retract the roller within the kit. Many thanks

Hi, I need to replace the rollers shown in the attached picture for 18 sliding glass doors for a total of 72 rollers (one set of rollers is duplicated). The original hardware shown comes from a 1962 home and only marking found were the name "KILIAN"

I need to purchase two sliding glass door rollers. I see several in your inventory that look like mine. Can you narrow down the part number based on the uploaded photos. Stamp on rollers show: ASTR BEC OMCO