Viewing all customer Discussions for:

81-083 Patio Glass Door Roller, 1-1/8" Steel BB Concave

Looking for a set of the attached rollers for 4 sliding glass doors. Doors are old aluminum double pane and I cannot locate a manufacturer name anywhere on the doors. Roller wheels appear to 1 1/4". If you need any further information please let me know

This sliding glass door has no name. number or markings. It probably dates back to around 1960. The width of the channel is 7/8"

Hi, I need to buy 2 more door rollers for a different sliding patio door. I don?t know the brand of the door, but I?ve attached photos of the roller unit removed from the door. Can you figure out what unit I need as a replacement? Thanks so much. Rob

Please reply if you carry these.

Attached are some photos of a patio door roller. Please match up if possible.

My roller looks like 81-083, and it has the same measurements. However, the part where the screw attaches it to the door, does not have the offset, but is straight up (although it is slightly bent in the picture). Will that make a difference? Thanks! Dave

Can't seem to find anything simular

Attached are pictures of the patio door roller I am trying to match. This is for a door installed when my townhouse was built in 1975. I do not know the manufacture of the door nor are there any markings on the old roller.The roller measures 2 1/2" long by 1" high by 3/4" thick (at the widest point) ... (cont.)

I need to identify which rollers I need so I can order and replace don't have old rollers because they were replaced by wrong ones here are the pics of bottom rail 20150912_132443.jpg

My house was built in 1980, I purchased it in 2013, so I am not sure if the glass doors are original. Attached are pictures of the roller assemblies. The top of the photo has the complete assy, the bottom half is one I disassembled. On the disassembled one, you can see D-719 stamped on the side ... (cont.)

Do no thave any model numbers on hardware or doors, so having difficulty identifying these. Do you have a replacement that would work, based on my submitted pictures? These rollers are held in place to the door only by the extended plastic tab, through which one screw goes that also holds together ... (cont.)

I heard that you were able to help of I sent a few pics of what I'm having a hard time finding myself. Any Ideas? There are no numbers or identifying marks on this stupid thing sorry. Thanks, I hope, Paul

I ordered these patio door rollers (2) 81-039 but they were too big vertically and couldn't be adjusted low enough to install on the track. There is 1" of room in the patio door housing where the rollers would install and it's 3/8" space from the track insert to the edge of track housing. I need a r ... (cont.)

I am attaching 2 photos of the roller I took out of the patio door please match me one that would fit thankyou