Viewing all customer Discussions for:

82-002 Sliding Door Handle Set, 6-5/8"

Looking for a replacement handle for a guardian slider. Stamp on the slider says Guardian ANSI Z97.1 - 1984. Stamp is shown in one of the pictures. Thank you! - Ben

Black hardware with offset handle. 7 9/16 hole spacing

Patio Door Lock Needed to Include angular Handle Stand offs (2) and Requisite Handle. You can call me direct Jeff

Sliding Glass door handle. Opening is 8" Tall for hardware.

I have tried so many parts and cannot find this exact one. it seem that the part that holds the latch is too short on all the new replacement parts. Any suggestions as to where to find the exact part or to modify the new ones to fit? Thanks in advance for your help

I need a new exterior part of the sliding door lock.

The first image is of the inside; the second image is of the outside, and the third image is the lock part that is broken.

Looks like someone broke off the latch. I need a replacement or something else that uses similar hardware.

Door lock has "Sullivan and associates " stamped on it. Roller replacement kit?

I need a basic builders grade patio door flush handle in white, but for a door that's 1-3/4" thick. The lock I need looks just like the last picture but with an extra "step" where my pen is pointing to accommodate the thicker door. Measurement from screw to screw is 6-5/8". I've been unable to find ... (cont.)

6 1/2" between screws 1" between bottom screw hole and reversible latch screw hole 7 5/8" from top to bottom of lock plate 1 1/8" thick door

I have a corroded and broken sliding glass door handle. DNS industries outside pull 13/25 that needs replacing. 16 inside pull. The part that says locked has broken off from the inside lever. It is an old sliding glass door in a condo built in the late 1980s

I would like to buy this part from. you but am having trouble locating it on your site, its a DNS Industries 12 inside pull and I believe that the holes from centers is 6 1/2" apart. if you could give me the part number so I may purchase it that would be greatthank you Keith

Measures identical to 82-008 but is white. One screw hole is stripped. Need replacement.

No brand/manufacturer name anywhere on the door nor lock. Both the indoor and outdoor "faceplates" are 7-1/4" tall and 1" wide. The screw holes are 6-5/8 apart. The door is 1" wide. The latch hooks face in the UP direction.

The door opens to the left with the handle on the inside. The door is 1 in thick. Screw holes are 7.5 in apart. Hope you can help me. Thank you.

Looking for a handle for a patio door. The overall length is 7 1/4 inches long, the screws are 5 1/2 center to center and it measured a 1 inch wide. Thanks

I can't seem to find any brand or identifier for this lock on my sliding door. Do you have anything similar?

I have 3 sliders id like to replace the lock on as they dont lock very securely anymore. They are from 1984. They lock in the "up" position. They dont have a "night lock" feature but that would be great! The hole centerlines are 6-1/2". I have measured multiple times to be sure and that is what they ... (cont.)

Need a part identical to this part but for a sliding door that is 1.5" wide. This part does not have the latch centered. Can't use old parts on the new one because the screw threads are different.