Viewing all customer Discussions for:

82-020 Mortise Style Handle Set, 3-15/16"

We think to be an Old kk (Kolbe) Viewport sliding patio Door (1988). We measured the latch assembly to be .75" W x 4.375" H x 1.19" Deep. Screw hole Centerline is 3.5". The "L" is .75" to 1.0" depending where you measure. The centerline of the mortise is 3/4" from the inside door surface. W ... (cont.)

Exterior and interior door pulls. Locking mechanism ok. Scott

I have a patio door with a boken mortise lock. I've taken the door handle apart to see the mortise assy. Viewing your website part no. 82-218 appears to be the best match. (rounded ends) The only markings on the door or latch assy. is on the glass Gaurdian Carleton,Mich. I'm not sure about 45 deg. ... (cont.)

I have a glass sliding door that I would like to put an exterior lock on. Key lock on the outside, turn knob on the inside. The door is a Caradco brand door, part number cpdu1-60x68b. Caradco was bought out by Jeld-wen. I will have pictures to post a little later today. Any help would be apprecia ... (cont.)

We need to replace the simple lock on our sliding glass door but do not know which of your products will work for us. Please see the attached photos. Thanks.

The rectangular hole in the door is about 1/2" wide by 7 1/4" and the old lock is broken. The handle slid up-sown to lock. I need a replacement handle and lock. The existing handle is like 82-020. Your suggestions please! The problem has been in getting a handle that covers up the large hole in t ... (cont.)

So after being locked out on the patio, we are going to replace the door handle, mortise lock and keeper to make sure it doesn't happen again~ Am looking at part 82-020 as the handle. How do I know what lock and keeper goes with this part? Thank you, love your website and you guys! You are th ... (cont.)